We have performed a comprehensive test of the effects of alternative fuels on the trace gas, nonvolatile particulate material (PM), and volatile PM emissions performance of a PW308 aircraft engine. The tests evaluated standard JP-8 jet fuel, a "zero sulfur" and "zero aromatic" synthetic fuel produced from a natural gas feedstock using the Fischer-Tropsch (FT) process, and a 50/50 blend of the FT fuel and JP-8. A Pratt & Whitney PW308 engine was operated under the same thrust and combustion conditions to ensure that the tests captured fuel differences, rather than engine operation differences. Emissions of trace gases, soot particles, and nucleation/growth PM were directly impacted by the sulfur and aromatic content of the fuel. FT fuel combustion greatly reduced SO 2 (>90%), gaseous hydrocarbons (40%), and NO (6-11%) content compared to JP-8 combustion. In general, combustion of the JP-8/FT fuel blend resulted in emissions intermediate to the FT and JP-8 values. FT combustion dramatically reduces soot particle number, mass, and size relative to JP-8, but increases effective soot particle density. In all cases, the drag behavior of the soot particles indicates deviations from spherical shape and effective soot particle densities are consistent with the soot particles being aggregates of primary spherules. As expected, FT combustion plumes support negligible formation of nucleation/growth mode particles (the number of nucleation growth mode particles is <20% the number of soot particles compared to >500% for sulfur containing JP-8). However, particle nucleation/growth for blended fuel combustion is enhanced relative to JP-8, despite the lower sulfur content of the FT/JP-8 fuel blend. A computational model explains the unexpected particle formation result primarily as the effect of much lower soot emissions present in blended fuel combustion exhaust compared to JP-8. Fuel composition, specifically aromatic and sulfur content, affect all aspects of emissions performance and the effect of simultaneously reducing aromatic and sulfur content can lead to surprising behavior.

The Aircraft Alternative Fuels Emissions experiment (AAFEX) was conducted at National Aeronautic and Space Administration (NASA) Dryden Flight Research Center (DFRC) Aircraft Operations Facility (DAOF) in Palmdale, California, during January and February 2009. The purpose was to systematically investigate the effect of alternative fuels on both gas-phase and particle emissions from a CFM56-2C1 engine on NASA’s DC-8 aircraft parked on the ground as functions of engine power, fuel composition, and exhaust plume age. Emissions parameters were measured at 6 engine power settings, ranging from idle to maximum thrust, in samples collected at 1, 30, and 145 meters (m) downstream of the exhaust plane as the aircraft burned three pure fuels and two fuel blends. The fuels included JP-8, two fuels produced using the Fischer-Tropsch process and 50/50 blends by volume of the F-T fuels with JP-8. The 1 m sampling rakes contained multiple gas and particle inlet probes and could also be traversed in order to measure the spatial variation of emissions across the engine exhaust plane. The #2 inboard engine on the left side always burned JP-8 while the #3 inboard right side engine was fueled with the various fuels and fuel blends. In addition, emissions from the Auxiliary Power Unit (APU) were also evaluated with both JP-8 and one pure F-T fuel. Both gaseous and particulate emissions are presented. Results show that the synthetic fuels reduced pollutant emissions while having relatively little effect on engine operation or performance.

No abstract

A low-NO x aircraft gas turbine engine combustion concept was developed and tested. The concept is a second generation swirl-venturi lean direct injection (SV-LDI) concept. LDI is a lean-burn combustion concept in which the fuel is injected directly into the flame zone. Three second generation SV-LDI configurations were developed. All three were based on the baseline 9-point SV-LDI configuration reported previously. 1 These second generation configurations had better low power operability than the baseline 9-point configuration. Two of these second generation configurations were tested in a NASA Glenn Research Center flametube; these two configurations are called the flat dome and 5-recess configurations. Results show that the 5-recess configuration generally had lower NO x emissions than the flat dome configuration. Correlation equations were developed for the flat dome configuration so that the landing-takeoff NO x emissions could be estimated. The flat dome landing-takeoff NO x is estimated to be 87-88% below the CAEP/6 standards, exceeding the ERA project goal of 75% reduction.