With the substantial increase in the capacity of grid-connected photovoltaic (PV) power, the adverse effects of its complex fault characteristics on grid relay protection are increasingly highlighted. Based on the introduction of the topology and the control strategy on low-voltage ride through of PV power, a theoretical solution method for solving the fault current of PV power is proposed by taking account of the DC bus voltage fluctuation, and a theoretical calculation model of its transient and steady state is established. The correctness of the theoretical results is verified by the numerical simulation results and low-voltage ride through (LVRT) experiment results. Furthermore, to gain a better understanding of the factors influencing PV power fault characteristics, the effects of several factors including proportional integral (PI) controller parameters, fault voltage sag depth, and PV power load level on PV power fault characteristics are analyzed by using simple variable method. The obtained results can provide a theoretical reference for the control parameter design and protection research of PV power.

The short‐circuit current characteristics fed by the renewable energy source are quite different from those of the synchronous generator, which may lead to the phase selection error or failure of the traditional fault phase selection component, and then affect the operating reliability of the distance protection and the automatic reclosing. This study analyses the existing issues in the application of traditional phase selection components to the tie‐line of renewable energy power, according to the fault characteristics of different renewable energy sources such as photovoltaic power source, direct‐drive wind turbine and doubly‐fed wind turbine. Furthermore, the sequence voltage expressions in the case of different types of faults, which takes account of the influence of the renewable energy type and the transition resistance, are theoretically derived. Hereby, a novel phase selection method by using sequence‐voltage phase comparison and phase‐voltage amplitude comparison is proposed. This method is applicable to the tie line of different types of renewable energy power station, and possesses the superiorities of high reliability and strong tolerance towards large fault transition resistance. Digital simulation results verify the favourable performance of the proposed method.

Overhead transmission line faults are mostly single‐phase grounding faults, and to ensure the power supply reliability of photovoltaic power plants in the cases of tie line transient faults, a feasible solution is to employ the single‐phase reclosing. However, for the single‐phase reclosing of the tie line, photovoltaic power source may face the over‐voltage problem during the non‐full phase operation, which will seriously affect the success rate of the single‐phase reclosing. This paper, according to different non‐full phase operation control strategies of photovoltaic power source, establishes the corresponding sequence network analysis models, and proposes the theoretical calculation method of non‐full phase operation voltage, which takes account of different neutral point grounding modes of step‐up transformer and different load levels. Meanwhile, the closing impulse problem of the single‐phase reclosing is discussed. The correctness of the theoretical method is verified by digital simulation results. On this basis, the applicable scope and application suggestions of the single‐phase reclosing are given. The research conclusions can provide important guidance and reference for the application of single‐phase reclosing technology in tie line of renewable energy power plant.

No abstract

No abstract