The onset wavelengths of the surface photovoltage (SPV) in dye-sensitized solar cells (DSSCs) with different mesoporous, wide-band gap electron conductor anode materials, viz., TiO 2 (anatase), Nb 2 O 5 (amorphous and crystalline), and SrTiO 3 , using the same Ru bis-bipyridyl dye for all experiments, are different. We find a clear dependence of these onset wavelengths on the conduction band edge energies (E CB ) of these oxides. This is manifested in a blue-shift for cells with Nb 2 O 5 and SrTiO 3 compared to those with TiO 2 . The E CB levels of Nb 2 O 5 and SrTiO 3 are known to be some 200-250 meV closer to the vacuum level than that of our anatase films, while there is no significant difference between the optical absorption spectra of the dye on the various films. We, therefore, suggest that the blue shift is due to electron injection from excited-state dye levels above the LUMO into Nb 2 O 5 and SrTiO 3 . Such injection comes about because, in contrast to what is the case for anatase, the LUMO of the adsorbed dye in the solution is below the E CB of these semiconductors, necessitating the involvement of higher vibrational and/or electronic levels of the dye, with the former being more likely than the latter. While for Nb 2 O 5 hot electron injection has been proposed earlier, on the basis of flash photolysis experiments, this is the first evidence for such ballistic electron-transfer involving SrTiO 3 , a material very similar to anatase but with a significantly smaller electron affinity. Additional features in the SPV spectra of SrTiO 3 and amorphous Nb 2 O 5 (but not in those of crystalline Nb 2 O 5 ) can be understood in terms of hole injection from the dye into the oxide via intraband gap surface states.

Nanocrystalline titanium dioxide colloids have been synthesized using a sol-gel technique followed by growth under hydrothermal conditions in a basic environment at temperatures between 190 and 270 °C. Thin films have been made from aqueous suspensions of these colloids. X-ray analysis showed the colloids to be primarily the anatase crystal phase. Scanning electron microscopy (SEM) revealed a predominantly rodlike particle morphology after growth at lower temperatures and the formation of principally truncated tetragonal or tetrahydral bipyramidal nanocrystallites following growth at higher temperatures. The rodlike particles self-organize into regular cubic arrays with the long axis of the rods aligned perpendicular to the film surface. This self-organization is dependent upon the base used in colloidal synthesis and also upon the dielectric constant of the medium used during film formation.

The nucleation, growth, and orientation of lead zirconate titanate thin films prepared from organometallic precursor solutions by spin coating on (111) oriented platinum substrates and crystallized by rapid thermal annealing was investigated. The effects of pyrolysis temperature, post-pyrolysis thermal treatments, and excess lead addition are reported. The use of post-pyrolysis oxygen anneals at temperatures in the regime of 350-450 °C was found to strongly affect the kinetics of subsequent amorphous-pyrochlore-perovskite crystallization by rapid thermal annealing. The use of such post-pyrolysis anneals allowed films of reproducible microstructure and textures [both (100) and (111)] to be prepared by rapid thermal annealing. It is proposed that such anneals and pyrolysis temperature affect the oxygen concentration/average Pb valence in the amorphous films prior to annealing. Such changes in the Pb valence state then affect the stability of the transient pyrochlore phase and thus the kinetics of perovskite crystallization.

No abstract