The effect of vascular endothelial growth factor (VEGF) on skin flap survival and its ability to induce a pharmacological delay by promoting angiogenesis in a flap was studied in a rat transverse rectus abdominis musculocutaneous flap, using a 3 x 8-cm skin paddle with the inferior epigastric vessels as its main vascular supply. Forty-three Sprague-Dawley rats were divided into four groups. In group 1, VEGF was injected into the femoral vein after the flap was elevated. In group 2, VEGF was injected intra-arterially into the flap through the superior epigastric artery after the flap was elevated. In group 3, VEGF was injected into the subcutaneous fascial layer in the area where the flap would be dissected, and the flap was then raised 7 days after injection. In group 4, the flap was dissected and replaced, using saline injection as the control. On postoperative day 5, the survival area of each skin paddle was measured and the flap was harvested for histological analysis. The results showed that the mean survival area +/- standard deviation for the skin paddle was 6.82 +/- 4.89 cm2 (28.4 +/- 20.4% of the whole skin paddle) in the control group, and 4.2 +/- 3.0 cm2 (17.5 +/- 12.5%) and 6.02 +/- 5.97 cm2 (25.1 +/- 24.9%) in the groups with VEGF systemic and intra-arterial administration respectively. The skin survival area in the group with preoperative subcutaneous administration of VEGF was 17.85 +/- 2.88 cm2 (74.4 +/- 12%), which was significantly higher than the other three groups (p < 0.01). Histological semiquantitative analysis showed increased neovascularization in the flap treated with VEGF preoperatively. The data demonstrate that preoperative treatment with VEGF can induce angiogenesis and enhance skin paddle survival in a musculocutaneous flap.

No abstract

A method for measuring three-dimensional kinematics that incorporates the direct cross-registration of experimental kinematics with anatomic geometry from Computed Tomography (CT) data has been developed. Plexiglas registration blocks were attached to the bones of interest and the specimen was CT scanned. Computer models of the bone surface were developed from the CT image data. Determination of discrete kinematics was accomplished by digitizing three pre-selected contiguous surfaces of each registration block using a three-dimensional point digitization system. Cross-registration of bone surface models from the CT data was accomplished by identifying the registration block surfaces within the CT images. Kinematics measured during a biomechanical experiment were applied to the computer models of the bone surface.The overall accuracy of the method was shown to be at or below the accuracy of the digitization system used. For this experimental application, the accuracy was better than ±0.1 mm for position and ±0.1° for orientation for linkage digitization and better than ±0.2 mm and ±0.2° for CT digitization.. Surface models of the radius and ulna were constructed from CT data, as an example application. Kinematics of the bones were measured for simulated forearm rotation. Screw-displacement axis analysis showed 0.1 mm (proximal) translation of the radius (with respect to the ulna) from supination to neutral (85.2° rotation) and 1.4 mm (proximal) translation from neutral to pronation (65.3° rotation). The motion of the radius with respect to the ulna was displayed using the surface models. This methodology is a useful tool for the measurement and application of rigid-body kinematics to computer models.2

No abstract

No abstract