No abstract

Flight feather moult in small passerines is realized in several ways. Some species moult once after breeding or once on their wintering grounds; others even moult twice. The adaptive significance of this diversity is still largely unknown. We compared the resistance to mechanical fatigue of flight feathers from the chiffchaff Phylloscopus collybita, a migratory species moulting once on its breeding grounds, with feathers from the willow warbler Phylloscopus trochilus, a migratory species moulting in both its breeding and wintering grounds. We found that flight feathers of willow warblers, which have a shaft with a comparatively large diameter, become fatigued much faster than feathers of chiffchaffs under an artificial cyclic bending regime. We propose that willow warblers may strengthen their flight feathers by increasing the diameter of the shaft, which may lead to a more rapid accumulation of damage in willow warblers than in chiffchaffs.

No abstract

No abstract

The moisture-induced warping of three-layered crosslaminated solid wood panels made of Norway spruce was studied. The panels were exposed to different climate conditions at 65% and 100% relative humidity at the two panel faces. The results showed increasing cup deformation with an increasing relative thickness of the outer layers. The annual growth ring orientation was found to have a significant influence on the magnitude of the cup deformation. Measurements and numerical simulations of the moisture distribution within the panel were made in order to provide data for numerical simulations of the warping. A distinctive moisture profile with a conspicuous influence of the adhesive bond lines was found. The coefficient of diffusion of the adhesive bond lines was determined from the measurements and simulations. The mechanical material model used for the warping simulations takes into account elastic strain, moisture-induced swelling, and mechano-sorptive strain. The simulations showed good agreement with the warping test results. The most important material parameters for the cup deformation, which were identified in a parametric study of a panel with vertically oriented annual rings, are the moduli of elasticity and the swelling coefficients in the longitudinal and radial direction. Furthermore, the mechano-sorptive coefficient in radial direction was found to have a significant influence on warp.