Turning is one of the initial basic machining operation that prevails in assembly and production process. Modern techniques have been practices in rapid and eco-friendly production systems. Present study deals with the investigation of turning process on EN 18 steel which is been shown its existence in automobiles industries. Turning operation was performed using a coated tool insert with varying cutting speed (100, 125 and 150 mm/min), feed rate (0.05, 0.5, 0.15 mm/rev) and depth of cut (0.4, 0.8, 1.2 mm) at both dry and MQL conditions. The results obtained was compared to optimize the effect of minimum quality lubrication on surface roughness. Experimentally it was observed that speed of 100 m/min with combination of feed of 0.05 mm/rev and 0.4 mm depth of cut was found to be optimized for surface roughness in both the cases. The mathematical model generated for surface roughness and MRR for both dry and MQL turning models having better regression fit as it closer to 100. From ANOVA analysis feed was proved to be the highest contributing factor for surface roughness and for MRR speed is the most significant factor for both dry and MQL turning