Background: Ankle arthrodesis is an established treatment for ankle arthritis. For patients with ankle arthritis, the position of the talus during ankle arthrodesis may affect the radiographic parameters of the foot. The purpose of this study is to assess the radiographic relationship between talar alignment and the longitudinal arch of the foot before and after ankle arthrodesis. Methods: We retrospectively reviewed a single-surgeon series of 30 patients who had undergone ankle arthrodesis. Measured parameters included the lateral tibiotalar angle (LTTA), lateral talometatarsal angle (LTMA), lateral talocalcaneal angle (LTCA), cuneiform height (CH), and calcaneal pitch (CP). Additional data collected included demographics, fusion construct type, and visual analog scale (VAS) measurements. Results: LTTA was increased from 68.2 ± 7.4 degrees preoperatively to 75.0 ± 6.4 degrees postoperatively ( P = .001), LTMA increased from −2.0 ± 10.7 degrees to 4.0 ± 10.1 degrees ( P < .001), CH increased from 20.1 ± 7.5 mm to 26.1 ± 8.4 mm ( P < .001), LTCA and CP had no statistically significant change. VAS score decreased from 5.7 ± 2.7 to 1.3 ± 1.9 ( P < .001). Conclusion: Correcting the talar alignment in the sagittal plane during ankle arthrodesis improved the radiographic parameters of the foot, contributing to restoration of the longitudinal arch. The clinical significance of these findings is that in patients undergoing ankle arthrodesis, the surgeon should be aware that the alignment of the foot will be altered at the time of ankle arthrodesis and should be considered in preoperative planning. Further research is needed to determine the effect of ankle arthrodesis in patients determined to have pes planus preoperatively. Level of Evidence: Level III, retrospective cohort study.

Middle to distal-third clavicular shaft fractures are commonly treated with precontoured anterior plating. Some surgeons use mini-fragment plate fixation and position these plates on the anterior clavicle. Recent studies demonstrated the advantages of anterior clavicle plating, including a possible biomechanical advantage with cantilever bending forces and less subsequent implant removal. The insertion and positioning of anteriorly based clavicle plates requires the release of a portion of the anterior deltoid origin from the lateral clavicle. The purpose of this study is to evaluate the anatomy of the deltoid in relation to the clavicle and to determine the percentage of the deltoid origin released to place modern anterior precontoured plates.Methods: Six right and 4 left cadaver shoulders were dissected, each from separate cadaveric specimens (6 male and 4 female). All measurements were made with digital calipers. The length of the clavicle was measured from the acromioclavicular joint to the sternoclavicular joint. The length of deltoid origin on the lateral clavicle was measured from the acromioclavicular joint to the most medial attachment of the deltoid on the clavicle. Percentage of clavicle with deltoid origin was subsequently calculated. Results:The average length of the cadaveric clavicles was 164.4 mm with a range from 134.3 to 178.1 mm. The average amount of deltoid origin on the clavicle was 58.7 mm with a range from 43.4 to 69 mm. On average 35.5% of the clavicle had deltoid origin, with a range from 30.2% to 38.8%. Conclusion:On average, 35.5% of the clavicular osseous anatomy contains deltoid origin. This should be taken into consideration when performing anterior plating for clavicle fractures. With a significant portion of deltoid origin elevated, surgeons may consider altering postoperative protocols until some interval healing has occurred to this anterior head of the deltoid.