Sensors based upon surface-enhanced Raman spectroscopy (SERS) are attractive because they have narrow, vibrationally specific spectral peaks that can be excited using red and near-infrared light which avoids photobleaching, penetrates tissue, and reduces autofluorescence. Several groups have fabricated pH nanosensors by functionalizing silver or gold nanoparticle surfaces with an acidic molecule and measuring the ratio of protonated to deprotonated Raman bands. However, a limitation of these sensors is that macromolecules in biological systems can adsorb onto the nanoparticle surface and interfere with measurements. To overcome this interference, we encapsulated pH SERS sensors in a 30 nm thick silica layer with small pores which prevented bovine serum albumin (BSA) molecules from interacting with the pH-indicating 4-mercaptobenzoic acid (4-MBA) on the silver surfaces but preserved the pH-sensitivity. Encapsulation also improved colloidal stability and sensor reliability. The noise level corresponded to less than 0.1 pH units from pH 3 to 6. The silica-encapsulated functionalized silver nanoparticles (Ag-MBA@SiO(2)) were taken up by J774A.1 macrophage cells and measured a decrease in local pH during endocytosis. This strategy could be extended for detecting other small molecules in situ.

We report a high-spatial resolution imaging technique to measure optical absorption and detect chemical and physical changes on surfaces embedded in thick tissue. Developing sensors to measure chemical concentrations on implanted surfaces through tissue is an important challenge for analytical chemistry and biomedical imaging. Tissue scattering dramatically reduces the resolution of optical imaging. In contrast, X-rays provide high spatial resolution imaging through tissue but do not measure chemical concentrations. We describe a hybrid technique which uses a scanning X-ray beam to irradiate Gd(2)O(2)S scintillators and detect the resulting visible luminescence through the tissue. The amount of light collected is modulated by optical absorption in close proximity to the luminescence source. By scanning the X-ray beam, and measuring total amount of light collected, one can measure the local absorption near scintillators at a resolution limited by the width of luminescence source (i.e. the width of the X-ray excitation beam). For proof of principle, a rectangular 1.7 mm scanning X-ray beam was used to excite a single layer of 8 μm Gd(2)O(2)S particles, and detect the absorption of 5 nm thick silver island film through 10 mm of pork. Lifetime and spectroscopic measurements, as well changing the refractive index of the surroundings indicate that the silver reduces the optical signal through attenuated total internal reflection. The technique was used to image the dissolution of regions of the silver island film which were exposed to 1 mM of H(2)O(2) through 1 cm of pork tissue.

Silver nanobelts were synthesized without any external seeds or templates using a facile hydrothermal route via citrate reduction in the presence of hydrochloric acid. Both H+ and Cl– ions in HCl are important for the generation of nanobelts. The morphology can be controlled by varying the concentration of HCl and citrate. The obtained nanobelts have 3D orientation-dependent optical properties. By tracking the transportation and rotation of the nanobelts in cells or other biosystems, useful information related to the physical or chemical surroundings may be obtained.

Alginate gels are widely used for drug delivery and implanted devices. The rate at which these gels break down is important for controlling drug release. Since the de-gelation may be different in vivo, monitoring this process in situ is essential. However, it is challenging to monitor the gel through tissue due to optical scattering and tissue autofluorescence. Herein we describe a method to detect through tissue the chemically-induced changes in viscosity and de-gelation process of alginate gels using magnetically modulated optical nanoprobes (MagMOONs). The MagMOONs are fluorescent magnetic microspheres coated with a thin layer of opaque metal on one hemisphere. The metal layer prevents excitation and emission light from passing through one side of the MagMOONs, which creates orientation-dependent fluorescence intensity. The magnetic particles also align in an external magnetic field and give blinking signals when they rotate to follow an external modulated magnetic field. The blinking signals from these MagMOONs are distinguished from background autofluorescence and can be tracked on a single particle level in the absence of tissue, or for an ensemble average of particles blinking through tissue. When these MagMOONs are dispersed in calcium alginate gel, they become sensors for detecting gel degradation upon addition of either ammonium ion or alginate lyase. Our results show MagMOONs start blinking approximately 10 minutes after 2 mg/mL alginate lyase addition and this blinking is clearly detected even through up to 4 mm chicken breast. This approach can potentially be employed to detect bacterial biofilm formation on medical implants by sensing specific proteases that either activate a related function or regulate biofilm formation. It can also be applied to other biosensors and drug delivery systems based on enzyme-catalyzed breakdown of gel components.