Objective: This paper documents our experience using the Cleaner XT device (Argon Medical Devices, Plano, TX, USA) for pharmacomechanical thrombolysis (PMT) of thrombosed haemodialysis arteriovenous grafts (AVG) and fistulas (AVF). Materials and Methods: This was a retrospective case series (n=17) over six months at Singapore General Hospital. We evaluated demographics, procedural data, technical and procedural success, patency rates and complications. Results: There were 8 (47%) males and the patients mean age was 66 (± 5.7) years. The mean age of AVF/AVG was 1605 (± 1099) days. All procedures were performed under local anaesthetic. PMT was performed within a mean time of 40 (±34.3) hours from the presentation. Technical, clinical and procedural success was 15/17 (88%). The thrombolysis agents used were tissue plasminogen activator (52.9%) and urokinase (41.2%). Mean primary patency time was 114 (± 116) days, with a 65% 1-month and 47% 3-month primary patency rates. The mean secondary patency time was 155 (±132) days, with 76% one-month and 65% threemonth secondary patency rates, respectively. AVF rupture occurred in 3/17 (18%) cases but did not involve loss of the access circuit. Conclusion: The Cleaner XT device is a safe, minimally invasive endovascular tool for PMT in thrombosed AVF/AVG, with relatively high success and low complication rates.

Background: Early active motion protocols have shown better functional outcomes in zone II flexor tendon lacerations. Different techniques of tendon repair have different effects on gliding resistance, which can impact tendon excursion and adhesion formation. For successful initiation of early active mobilisation, the repair technique should have high breaking strength and low gliding resistance. Previous studies have shown the Modified Lim-Tsai technique demonstrates these characteristics. The Asymmetric repair has also shown superior ultimate tensile strength. This study aims to compare the gliding resistance between the two techniques. Methods: FDP tendons from ten fresh frozen cadaveric fingers were randomly divided into two groups, transected completely distal to the sheath of the A2 pulley and repaired using either the Modified Lim-Tsai or Asymmetric technique. The core repair was performed with Supramid 4-0 looped sutures and circumferential epitendinous sutures were done with nylon monofilament Prolene 6-0 sutures. The gliding resistance and ultimate tensile strength were then tested. Results: The gliding resistance of the Asymmetric and Modified Lim-Tsai repair techniques were 0.2 and 0.95 N respectively. This difference was significant (p = 0.008). The Modified Lim-Tsai technique had a higher ultimate tensile strength and load to 2 mm gap formation, though this was not significant. Conclusions: Gliding resistance of the Asymmetric repair is significantly less than that of Modified Lim-Tsai. Ultimate tensile strength and load to 2 mm gap formation are comparable.