No abstract

Manganese propane and manganese butane complexes derived from CpMn(CO)(3) were generated photochemically at 130-136 K with the alkane as solvent and characterized by FTIR spectroscopy and by (1)H NMR spectroscopy with in situ laser photolysis. Time-resolved IR spectroscopic measurements were performed at room temperature with the same laser wavelength. The ν(CO) bands in the IR spectra of the photoproducts in propane are shifted to low frequency with respect to CpMn(CO)(3), consistent with formation of CpMn(CO)(2)(propane). The (1)H NMR spectra conform to the criteria for alkane complexes: a high-field resonance for the η(2)-CH protons that shifts substantially on partial deuteration of the alkane and exhibits a coupling constant J(C-H) on (13)C-labeling of ca. 120 Hz. The NMR spectrum of each system exhibits two diagnostic product resonances in the high-field region for the η(2)-CH protons, corresponding to CpMn(CO)(2)(η(2)-C1-H-alkane) and CpMn(CO)(2)(η(2)-C2-H-alkane) isomers. Partial deuteration of the alkane at C1 results in characteristic strong isotopic perturbation of equilibrium of the η(2)-CH resonance of CpMn(CO)(2)(η(2)-C1-H-alkane). With propane-(13)C(1), the η(2)-CH resonance of CpMn(CO)(2)(η(2)-C1-H-alkane) isomer exhibits (13)C satellites with J(C-H) = 119 Hz. The corresponding resonance of CpMn(CO)(2)(η(2)-C2-H-alkane) is identified by use of propane-2,2-d(2). The lifetimes of the (η(2)-C1-H-alkane) isomers of the manganese complexes were determined by NMR spectroscopy as 22 ± 2 min at 134 K (propane) and 5.5 min at 136 K (butane). The corresponding spectra and lifetimes of the CpRe(CO)(2)(alkane) complexes were measured for reference (CpRe(CO)(2)(propane) lifetime ca. 60 min at 161 K; CpRe(CO)(2)(butane) 13 min at 171 K). The lifetimes determined by IR spectroscopy were similar to those determined by NMR spectroscopy, thereby supporting the assignments. These measurements extend the range of alkane complexes characterized by NMR spectroscopy from rhenium and rhodium derivatives to include less stable manganese derivatives.

Cationic Rh(I) and Ir(I) complexes of the form [M(PC)(COD)]BPh4 (M = Rh (4), Ir (5); PC = 3-[2-(diphenylphosphino)ethyl]-1-methylimidazol-2-ylidene) were synthesized by the addition of 3-[2-(diphenylphosphino)ethyl]-1-methylimidazolium (3) to [M(μ-OEt)(COD)]2 (M = Rh, Ir; COD = 1,5-cyclooctadiene) in the presence of base. COD was successfully displaced from [Rh(PC)(COD)]BPh4 (4) by addition of carbon monoxide to a methanol/hexane suspension to form [Rh(PC)(CO)2]BPh4 (6). The analogous addition of CO to the iridium compound 5 resulted in the formation of the five-coordinate Ir(I) complex [Ir(PC)(COD)(CO)]BPh4 (7). The single-crystal X-ray structures of 4, 5, and 7 were determined. The metal centers of 4 and 5 are square planar, and the metal center of 7 is a distorted trigonal bipyramid. Complexes 4−7 are effective as catalysts for the intramolecular hydroamination of 4-pentyn-1-amine to 2-methyl-1-pyrroline. Complete conversion (>97%) of 4-pentyn-1-amine was observed using complexes 4−7 as catalysts, in both chloroform-d and tetrahydrofuran-d 8. Reactions in chloroform-d in general exhibited higher turnover rates than reactions in tetrahydrofuran-d 8.

The synthesis of a series of iron and ruthenium complexes with the new ligand PP(i)(3) (1) P(CH(2)CH(2)P(i)Pr(2))(3) is described. The iron(0) and ruthenium(0) dinitrogen complexes Fe(N(2))(PP(i)(3)) (4) and Ru(N(2))(PP(i)(3)) (5) were synthesized by treatment of the iron(II) and ruthenium(II) cationic species [FeCl(PP(i)(3))](+) (2) and [RuCl(PP(i)(3))](+) (3) with potassium graphite under a nitrogen atmosphere. The cationic dinitrogen species [Fe(N(2))H(PP(i)(3))](+) (6) and [Ru(N(2))H(PP(i)(3))](+) (7) were prepared by treatment of 4 and 5, respectively, with 1 equiv of a weak organic acid. Complexes 2.[BPh(4)], 3.[BPh(4)], 4, 5, and 6.[BF(4)] were characterized by X-ray crystallography. The structural characterization of 5 is the first report for a ruthenium(0) dinitrogen complex.