This work reports the first results obtained using a new 3D radiochromic gel dosimeter. The dosimeter is an aqueous physical gel matrix made of poly(ethylene oxide)-block-poly(propylene oxide)-block-poly(ethylene oxide) (Pluronic F-127, PEO-PPO-PEO) doped with a representative of tetrazolium salts, 2, 3, 5-triphenyltetrazolium chloride (TTC). There were several reasons for the choice of Pluronic as a gel forming substrate: (i) the high degree of transparency and colourlessness; (ii) the possibility of gel dosimeter preparation at both high and low temperatures due to the phase behaviour of Pluronic; (iii) the broad temperature range over which the TTC-Pluronic dosimeter is stable; and (iv) the non-toxicity of Pluronic. A reason for the choice of TTC was its ionising radiation-induced transformation to water-insoluble formazan, which was assumed to impact beneficially on the spatial stability of the dose distribution. If irradiated, the TTC-Pluronic gels become red but transparent in the irradiated part, while the non-irradiated part remains crystal clear. The best obtained composition is characterised by <4 Gy dose threshold, a dose sensitivity of 0.002 31 (Gy  ×  cm), a large linear dose range of >500 Gy and a dynamic dose response much greater than 500 Gy (7.5% TTC, 25% Pluronic F-127, 50 mmol dm tetrakis). Temporal and spatial stability studies revealed that the TTC-Pluronic gels (7.5% TTC, 25% Pluronic F-127) were stable for more than one week. The addition of compounds boosting the gels' dose performance caused deterioration of the gels' temporal stability but did not impact the stability of the 3D dose distribution. The proposed method of preparation allows for the repeatable manufacture of the gels. There were no differences observed between gels irradiated fractionally and non-fractionally. The TTC-Pluronic dose response might be affected by the radiation source dose rate-this, however, requires further examination.

This work is a follow-up study for a recently-proposed 3D radiochromic gel dosimeter that contains a tetrazolium salt and a physical gel matrix made of poly(ethylene oxide)-block-poly(propylene oxide)-block-poly(ethylene oxide) (Pluronic F-127). Several tetrazolium salts were examined in this work, including tetrazolium violet, blue tetrazolium chloride, nitro blue tetrazolium chloride (NBT), tetranitro blue tetrazolium chloride (tNBT) and thiazolyl blue tetrazolium bromide (TBTB). The salt-containing gel dosimeters were compared with the first Pluronic gel composition that contained 2,3,5-triphenyltetrazolium chloride (TTC) as the radiation-sensitive component (dose sensitivity of 0.0023 (Gy cm)). The Pluronic gels with NBT and tNBT outperformed the other gels, including the TTC-containing gel, with respect to their dose sensitivity and low dose-response. The NBT gels were found to have better stability over time than tNBT gels. Sensitization of the gels to ionizing radiation was examined by addition of tert-butyl alcohol and sodium formate. The best composition was 0.0818% NBT (1 mM), 25% Pluronic F-127 and 0.136  ×  10% sodium formate. This gel dosimeter was insensitive to changes in dose rate for photons of different energies. The mean dose sensitivity amounted to 0.0047  ±  0.1  ×  10 (Gy cm). A diversion in the dose-response was observed for the gel irradiated with electrons. Additional characteristics of the NBT gel were a linear-dose range and a dynamic-dose range between <1 and  ⩾150 Gy and a dose threshold of <1 Gy. The dose distribution registered for the NBT-Pluronic gel was stable after irradiation for over 7 d with no visible diffusion of the irradiated part, which is analogous to the original TTC-Pluronic gel.

No abstract

A co-polymer of poly(ethylene oxide)-block-poly(propylene oxide)-block-poly(ethylene oxide) (Pluronic F-127, PEO-PPO-PEO) was proposed as a physical gel matrix, substituting gelatine for three-dimensional polymer gel dosimeters and as a matrix for the preparation of new radiochromic gel dosimeters. Two polymer gel dosimeters and seven radiochromic gel dosimeters were obtained with this new matrix. In this review we summarise the main advantages of using Pluronic F-127 for manufacturing radiation dosimeters and the best performing new Pluronic dosimeters.