There are reports that nano-sized zero-valent iron (Fe0) exhibits greater reactivity than micro-sized particles of Fe0, and it has been suggested that the higher reactivity of nano-Fe0 may impart advantages for groundwater remediation or other environmental applications. However, most of these reports are preliminary in that they leave a host of potentially significant (and often challenging) material or process variables either uncontrolled or unresolved. In an effort to better understand the reactivity of nano-Fe0, we have used a variety of complementary techniques to characterize two widely studied nano-Fe0 preparations:  one synthesized by reduction of goethite with heat and H2 (FeH2) and the other by reductive precipitation with borohydride (FeBH). FeH2 is a two-phase material consisting of 40 nm α-Fe0 (made up of crystals approximately the size of the particles) and Fe3O4 particles of similar size or larger containing reduced sulfur; whereas FeBH is mostly 20−80 nm metallic Fe particles (aggregates of <1.5 nm grains) with an oxide shell/coating that is high in oxidized boron. The FeBH particles further aggregate into chains. Both materials exhibit corrosion potentials that are more negative than nano-sized Fe2O3, Fe3O4, micro-sized Fe0, or a solid Fe0 disk, which is consistent with their rapid reduction of oxygen, benzoquinone, and carbon tetrachloride. Benzoquinonewhich presumably probes inner-sphere surface reactionsreacts more rapidly with FeBH than FeH2, whereas carbon tetrachloride reacts at similar rates with FeBH and FeH2, presumably by outer-sphere electron transfer. Both types of nano-Fe0 react more rapidly than micro-sized Fe0 based on mass-normalized rate constants, but surface area-normalized rate constants do not show a significant nano-size effect. The distribution of products from reduction of carbon tetrachloride is more favorable with FeH2, which produces less chloroform than reaction with FeBH.

Uptake of ferrous iron from aqueous solution by iron oxides results in the formation of a variety of reactive surface species capable of reducing polyhalogenated methanes (PHMs). Pseudo-first-order reaction rate constants, k(obs), of PHMs increased in the order CHBrCl2 < CHBr2Cl < CHBr3 < CCl4 < CFBr3 < CBrCl3 < CBr2Cl2. The k(obs) values increased with the exposure time, teq, of Fe(II) to suspended iron oxides which was attributed to the rearrangement of initially sorbed Fe(II) species to more reactive surface species with time. At pH 7.2, the k(obs) values of PHMs also increased with the concentration of surface-bound ferrous iron, Fe(II)sorb, particularly when Fe(II)tot was increased to concentrations where surface precipitation becomes likely. At fixed total Fe(II) concentrations, k(obs) values increased exponentially with pH. The highest reactivities were associated with pH conditions where surface precipitation of Fe(II) is expected. Fe(II)sorb and pH, however, had opposite effects on the product formation of PHMs. At pH 7.2, the formation of formate from CX4 (X = CI, Br) increased with Fe(II)sorb, whereas increasing pH favored the formation of CHX3. The ratio of halogenated products and formate formed is indicative of the relative importance of initial one- or two-electron-transfer processes, respectively, and was found to depend on the type of iron oxide mineral also. Our data form a basis to assess the importance of chemical reactions in natural attenuation processes of PHMs in environmental systems under iron-reducing conditions.

No abstract