A design for a compact x-ray light source (CXLS) with flux and brilliance orders of magnitude beyond existing laboratory scale sources is presented. The source is based on inverse Compton scattering of a high brightness electron bunch on a picosecond laser pulse. The accelerator is a novel high-efficiency standingwave linac and rf photoinjector powered by a single ultrastable rf transmitter at X-band rf frequency. The high efficiency permits operation at repetition rates up to 1 kHz, which is further boosted to 100 kHz by operating with trains of 100 bunches of 100 pC charge, each separated by 5 ns. The entire accelerator is approximately 1 meter long and produces hard x rays tunable over a wide range of photon energies. The colliding laser is a Yb∶YAG solid-state amplifier producing 1030 nm, 100 mJ pulses at the same 1 kHz repetition rate as the accelerator. The laser pulse is frequency-doubled and stored for many passes in a ringdown cavity to match the linac pulse structure. At a photon energy of 12.4 keV, the predicted x-ray flux is 5 × 10 11 photons=second in a 5% bandwidth and the brilliance is 2 × 10 12 photons=ðsec mm 2 mrad 2 0.1%Þ in pulses with rms pulse length of 490 fs. The nominal electron beam parameters are 18 MeV kinetic energy, 10 microamp average current, 0.5 microsecond macropulse length, resulting in average electron beam power of 180 W. Optimization of the x-ray output is presented along with design of the accelerator, laser, and x-ray optic components that are specific to the particular characteristics of the Compton scattered x-ray pulses.

We demonstrate intracavity gain shaping inside a 2 μm Ho:YLF regenerative amplifier with a spectral bandwidth of 2.9 nm broadened to 5.4 nm, corresponding to Fourier-limited pulses of 1 ps duration. The intracavity gain shaping is achieved by using a simple etalon, which acts as a frequency-selective filter. The output of the regenerative amplifier is amplified by a single-pass amplifier, and we achieve total energy of 2.2 mJ and pulse duration of 2.4 ps at 1 kHz with pulse fluctuations <1%. The amplifier chain is seeded by a home-built mode-locked holmium-doped fiber oscillator.