No abstract

The Stø Formation is the most important reservoir interval in the Norwegian Barents Sea, however the reservoir quality can be highly affected by the detrimental effects of quartz cement where there have been extensive post depositional burial. Core plug data from well 7219/8-2 in the Southwestern Barents Sea shows abnormally high porosity and permeability values in certain units of the deeply buried and otherwise highly quartz cemented Stø Formation. The amount of quartz cement in the samples is inversely proportional to the porosity. Samples with high and low porosities are similar texturally and mineralogically, but the high porosity samples have a layer of illitic clay coating the majority of the detrital quartz grains. Illitic clay coating present at grain contacts can result in a lowered IGV given they aid in the dissolution of quartz at interfaces, also creating a source of dissolved silica. Clay induced dissolution means that silica saturation is not a limiting factor in quartz cementation in these samples. The results show that the illitic clay coating is capable of limiting the amount of authigenic quartz overgrowth from 20-23% in samples with negligible grain coating to 5-11% in the intervals with high coating coverage. The illitic clay coating inhibits quartz overgrowth by limiting the surface area available for nucleation on detrital grains. The Stø Formation comprises mainly shallow marine deposits of highly reworked clean sandstone. Abnormally high porosities appear to be linked to settings where sediments of a more proximal location are preserved without extensive reworking. The grain coating clay is illitic and most likely originates from clay infiltration processes prior to final deposition. The difference in extent of clay coating in similar facies can mostly be correlated with varying amount of post depositional reworking. This study suggests that there is a potential for considerable porosity and permeability to be preserved in deeply buried sandstones in the Barents Sea. This study could be important in the future exploration activity of deeply buried structures in the area.

Sediment gravity flows transport large volumes of sand and clay minerals into submarine systems, which store some of the world's major reserves of oil and gas. However, knowledge about grain‐coating clay mineral formation and its role in preserving reservoir quality in deep marine settings is poorly documented. Here we present a case study on the Agat Formation, a deep marine deposit interpreted as a series of turbidites, using a multimethod approach including petrographical, petrophysical and sedimentological data. This study investigates the occurrence and origin of chlorite coating and demonstrates how extensive chlorite coating substantially affects reservoir quality. The presence of green marine clay pellets suggests an initial shallow marine origin and sedimentological evidence reveals that the sediments were later remobilized by gravity flows and deposited at their present location. We suggest that the precursor clay coating was emplaced prior to sediment remobilization because of the presence of clay coating on grain contacts and all detrital components, the continuous nature of coating and the lack of clay bridges between the grains. Therefore, the origin of chlorite coating in deep marine environments may be recognized using the characteristic properties of inherited precursor clay coating. Chlorite coating thickness varies between an upper and lower sand unit, with an average of ca. 4.5 µm and ca. 24 µm, respectively. Permeability is significantly reduced in the interval with exceedingly thick chlorite coating but shows only a subtle decrease in helium porosity. This study enlightens the importance of crucially evaluating porosity in sandstones with thick chlorite coating using a multimethod approach. The results from this study can be useful in future exploration endeavours in the area and in other deep marine systems with a similar setting worldwide.