The market demand for vehicles with reduced energy consumption, as well as increasingly stringent standards limiting CO2 emissions, are the focus of a large number of research works undertaken in the analysis of the energy consumption of cars in real operating conditions. Taking into account the growing share of hybrid drive units on the automotive market, the aim of the article is to analyse the total unit energy consumption of a car operating in real road conditions, equipped with an advanced hybrid drive system of the PHEV (plug-in hybrid electric vehicles) type. In this paper, special attention has been paid to the total unit energy consumption of a car resulting from the cooperation of the two independent power units, internal combustion and electric. The results obtained for the individual drive units were presented in the form of a new unit index of the car, which allows us to compare the consumption of energy obtained from fuel with the use of electricity supported from the car’s batteries, during journeys in real road conditions. The presented research results indicate a several-fold increase in the total unit energy consumption of a car powered by an internal combustion engine compared to an electric car. The values of the total unit energy consumption of the car in real road conditions for the internal combustion drive are within the range 1.25–2.95 (J/(kg · m)) in relation to the electric drive 0.27–1.1 (J/(kg · m)) in terms of instantaneous values. In terms of average values, the appropriate values for only the combustion engine are 1.54 (J/(kg · m)) and for the electric drive only are 0.45 (J/(kg · m)) which results in the internal combustion engine values being 3.4 times higher than the electric values. It is the combustion of fuel that causes the greatest increase in energy supplied from the drive unit to the car’s propulsion system in the TTW (tank to wheels) system. At the same time this component is responsible for energy losses and CO2 emissions to the environment. The results were analysed to identify the differences between the actual life cycle energy consumption of the hybrid powertrain and the WLTP (Worldwide Harmonized Light-Duty Test Procedure) homologation cycle.

No abstract

No abstract

On the basis of road tests, the authors assessed the feasibility of the vehicle body acceleration values for the purposes of assessing road surface characteristics in terms of its roughness. Short-term Fourier Transform (STFT) was used for the analysis of the recorded signal. The spectra obtained in successive frequency bands demonstrate the amplitudes originating from the natural vibrations of the rolling wheel and forces resulting from the interaction with the road roughness. The article focuses on the relationships between the road roughness and the ratios of individual amplitudes in a specific frequency band of the vehicle body acceleration values. Amplitude values derived on the basis of successive windows were averaged for analogous, arbitrarily assumed local frequency bands. The value characterizing the road surface condition provided the information regarding the mean amplitude value in specific frequency ranges depending on the instantaneous velocity of the car body and the condition of the road surface on which it was moving. In cases where the road was free of any visible roughness, the obtained mean amplitude value in the analyzed spectrum window, for the adopted vehicle velocity range from 50 km h to 100 km/h, did not exceed 0.02 m/s2. It was also demonstrated that the road surface roughness leads to an increase in the mean amplitude value from 0.07 m/s2 to 0.16 m/s2.

Abstract. Article defines on the possibility of reduction CO 2 of the internal combustion engine and presents the analysis based on originally conducted studies. The increase in overall engine efficiency is sought after by all engineers dealing with engine construction, one of the major ways to reduce CO 2 emissions is to increase the compression ratio. The application of the compression ratio that has been increased constructional in the engine will, on one hand, bring about the increase in the theoretical efficiency, but, on the other hand, require a system for pressure control at a higher engine load in order to prevent engine knocking. For the purposes of the article there was carried out a number of studies and compiled results, and on their basis determined what have a major impact on the reducing CO 2 .