Growth in poultry sector is being challenged due to increased incidence and re-emergence of diseases caused due to evolution of several viral pathogens and use of live vaccines. Piles of economic losses are encountered due to these diseases. Avian Infectious Bronchitis (IB), caused by Corona virus, is OIE-listed disease and characterized by respiratory, renal and urogenital involvements, causing high mortality. Economic losses are encountered due to loss of productive performance of both egg and meat-type chickens. Variant viruses evolve due to spontaneous mutations and recombinations, causing disease in vaccinated flocks of all ages. Serotyping and genotyping are the common methods of classification of IBV strains. The virus has 4 clusters, grouped into 7 serotypes and the most important strains are Massachusetts, Connecticut, Arkansas, Gray, Holte and Florida along with numerous others, distributed round the globe. Several conventional and molecular diagnostic methods have been described for the diagnosis of IB in chickens. 'All-in/all-out' operations of rearing along with good biosafety measures forms the basis of prevention, whereas vaccination forms the backbone of IB control programme. Both live and inactivated (oil emulsified) conventional vaccines are available. The new generation vaccines (recombinant and vector-based) developed against locally prevailing IBV strains may be more helpful and avoid the reversion of virulence in live vaccine viruses. The present review deals with all these perspectives of this important emerging poultry pathogen.

No abstract

Isolated medial cuneiform dislocation along with lisfranc dislocation is a very rare injury. A case report of this type of injury is presented to highlight the rarity of the injury and to emphasize the importance of thorough clinico-radiological examination to aid in the diagnosis. Open reduction and internal fixation is the treatment of choice.

Objective:To determine the resistance failure value of nonprecious metal-ceramic restorations at the incisal edge with varying thickness under different application of load. Materials and methods:An Ivorian central incisor was prepared to receive metal-ceramic crown, which was further duplicated, invested, casted and 72 metal dies were fabricated in Co-Cr alloy. Metal dies were relieved with die spacer, lubricated and wax patterns were prepared for metal copings, which were further invested and casted and 72 metal copings were fabricated. The ceramic materials were used for the study viz. Vita/VMK, IPSd SIGN, and superporcelain. Ceramic built-up was carried out according to manufacturer instructions. Incisal ceramic built-up was carried out with increasing thickness from 2.00 to 2.5 and 3.00 mm.Results: A total of 72 samples, prepared for the study, were divided into two groups, i.e. group I (36 samples) and group II (36 samples), as per the direction of application of load. The samples were mounted on acrylic block (6 samples/block). A total 12 acrylic blocks were prepared. All the samples were tested using universal testing machine (MTS/USA). The load was applied with crosshead speed of 5 mm/min. Conclusion:Fracture resistance was found to be highest for the 2.00 mm and lowest for 3.00 mm incisal ceramic thickness samples regardless of the ceramic material in both groups. There was a gradual decrease in fracture resistance as the incisal ceramic thickness increased from 2.00 to 3.00 mm in all samples. Fracture resistance was marginally higher for incisal ceramic build-up of 3 mm thickness on group II metal copings than on group I copings. Fracture resistance was highest for IPSd SIGN followed by that of Vita/VMK-95 and superporcelain.Clinical significance: A 3.00 mm incisal ceramic thickness offered greater fracture resistance in comparison to lower values of incisal thickness; IPSd SIGN offered greatest fracture resistance followed by that of Vita/VMK-95 and superporcelain.