No abstract

The goal of this study was to investigate the effect of die nozzle dimensions, barrel temperature profile, and moisture content on DDGS‐based extrudate properties and extruder processing parameters. An ingredient blend containing 40% distillers dried grains with solubles (DDGS), along with soy flour, corn flour, fish meal, whey, mineral and vitamin mix, with a net protein content adjusted to 28% was extruded in a single‐screw laboratory extruder using seven different die nozzles. Increasing moisture content of the ingredient mix from 15 to 25% resulted in a 2.0, 16.0, 16.3, 22.9, 18.5, 32.5, and 63.7% decrease, respectively, in bulk density, water‐solubility index, sinking velocity, L*, b*, mass flow rate, and absolute pressure, as well as 11.6, 16.2, and 7% increases, respectively, in pellet durability, water‐absorption index, and a*. Increasing the temperature from 100 to 140°C resulted in 17.0, 5.9, 35.4, 50.6, 28.8, 33.9, and 33.9% decreases, respectively, in unit density, pellet durability, sinking velocity, absolute pressure, specific mechanical energy, torque, and apparent viscosity, but a 49.1 and 16.9% increase, respectively, in dough temperature and water‐absorption index. Increasing the L/D ratio of the die nozzle resulted in an increase in bulk density, L*, a*, and torque, but a decrease in unit density, pellet durability, water‐absorption index, sinking velocity, b*, mass flow rate, dough temperature, and apparent viscosity. As demonstrated in this study, the selection of an appropriate die geometry, in addition to the selection of suitable temperature and moisture content levels, are critical for producing DDGS‐based extrudates with optimum properties.

No abstract

Extrusion trials were conducted with varying levels of distillers dried grains with solubles (DDGS) along with soy flour, corn flour, fish meal, vitamin mix, mineral mix, and net protein content adjusted to 28% using a Wenger TX‐52 twin‐screw extruder. The properties of extrudates were studied in experiments conducted using a full‐factorial design with three levels of DDGS content, two levels of moisture content, and two levels of screw speed. Increasing the DDGS content from 20 to 60% resulted in a 36.7% decrease in the radial expansion, leading to a 159 and 61.4% increase in the unit density and bulk density of the extrudates, respectively. Increasing the DDGS content resulted in a significant increase in the water absorption index (WAI) but a significant decrease in the water solubility index (WSI) of the extrudates. Changing the screw speed and moisture content had no significant effect on the radial expansion ratio but resulted in a significant difference in the bulk density of the extrudates, which may be due to the occurrence of longitudinal expansion. Even though changing the moisture content and screw speed had no significant effect on the WSI of the extrudates, significant differences in the WAI of the extrudates were observed. The ingredient components in the blend and moisture content had an influence on the color changes of the extrudates, as did the biochemical changes occurring inside the barrel during processing. Overall, it was determined that DDGS could be included at a rate of up to 60% using twin‐screw extrusion, and that viable pelleted floating feeds can be produced.