The primary purpose of this study was to investigate the feasibility of applying polymeric cementitious materials to three-dimensional additive construction (3DAC). Specifically, styrene–butadiene rubber (SBR) latex was employed as an admixture to produce SBR-modified cementitious mixtures, and their fresh properties were experimentally investigated to determine the feasibility of their use in the 3DAC process. The SBR/cement ratio was controlled based on four main materials (i.e., cement, sand, silica fume, and fly ash) in order to determine the optimal fresh properties. The test results revealed that the SBR-modified cementitious mixtures showed excellent flowability, extrudability, buildability, and open time, all of which are required for 3DAC materials. The optimal flow of the SBR-modified cementitious mixtures was 70% ± 1%, which is appropriate for 3DAC applications. According to the experiment results, the SBR-modified cementitious mixtures were sufficiently competitive to serve as a new class of materials for 3D additive construction.

The properties of normal cementitious mixtures currently employed to the construction projects cannot be used to the three-dimensional concrete printing technology. This study experimentally investigated the compressive and flexural strength development of styrene-butadiene rubber (SBR)-modified cementitious mixtures for use as basic three-dimensional concrete printing (3DCP) materials. The SBR/cement ratio was a variable of the mix proportion used to produce cast and printed specimens. Experiments were conducted using these specimens to determine the compressive and flexural strength levels of the SBR-modified cementitious mixtures. The results indicated that the compressive strengths of the SBR-modified cementitious mixtures proposed in this study were never less than those of existing 3D concrete printing materials previously introduced for 3DCP applications. It was confirmed that the addition of SBR latex effectively improved the strength of the cementitious mixtures because the relative compressive and flexural strengths increased with increases in the SBR/cement ratio. Moreover, the higher early (i.e., 1-day) strength indicates that the SBR-modified cementitious mixtures would be advantageous to the 3DCP process. However, the compressive and flexural strengths of the printed specimens were weaker than those of the cast specimens.