Silicon (Si) is considered to be one of the most promising anode candidates for next-generation lithium-ion batteries because of its high theoretical specific capacity and low discharge potential. However, its poor cyclability, caused by tremendous volume change during cycling, prevents commercial use of the Si anode. Herein, we demonstrate a high-performance Si anode produced via covalent bond formation between a commercially available Si nanopowder and a linear polymeric binder through an esterification reaction. For efficient ester bonding, polyacrylic acid, composed of −COOH groups, is selected as the binder, Si is treated with piranha solution to produce abundant −OH groups on its surface, and sodium hypophosphite is employed as a catalyst. The as-fabricated electrode exhibits excellent high rate capability and long cycle stability, delivering a high capacity of 1500 mA h g–1 after 500 cycles at a high current density of 1000 mA g–1 by effectively restraining the susceptible sliding of the binder, stabilizing the solid electrolyte interface layer, preventing the electrode delamination, and suppressing the Si aggregation. Furthermore, a full cell is fabricated with as-fabricated Si as an anode and commercially available LiNi0.6Mn0.2Co0.2O2 as a cathode, and its electrochemical properties are investigated for the possibility of practical use.

Ni-rich layered LiNi x Co y Mn 1−x−y O 2 (LNCM) with Ni content over >90% is considered as a promising lithium ion battery (LIB) cathode, attributed by its low cost and high practical capacity. However, Ni-rich LNCM inevitably suffers rapid capacity fading at a high state of charge due to the mechanochemical breakdown; in particular, the microcrack formation has been regarded as one of the main culprits for Ni-rich layered cathode failure. To address these issues, Ni-rich layered cathodes with a textured microstructure are developed by phosphorous and boron doping. Attributed by the textured morphology, both phosphorous-and boron-doped cathodes suppress microcrack formation and show enhanced cycle stability compared to the undoped cathode. However, there exists a meaningful capacity retention difference between the doped cathodes. By adapting the various analysis techniques, it is shown that the boron-doped Ni-rich layered cathode displays better cycle stability not only by its ability to suppress microcracks during cycling but also by its primary particle morphology that is reluctant to oxygen evolution. The present work reveals that not only restraint of particle cracks but also suppression of oxygen release by developing the oxygen stable facets is important for further improvements in state-of-the-art Li ion battery Ni-rich layered cathode materials.

Tin phosphide (Sn4P3) has emerged as an anode for sodium ion batteries (SIBs) due to its high reversible capacity and low redox potential.