Three lines of green chemistry were combined in this study, in order to produce porous materials with pore size distributions in the micro-and nano-scales. These lines are: (i) the renewable and biodegradable sources (cellulose), (ii) ionic liquids, and (iii) supercritical fluids. By dissolving cellulose in a room temperature ionic liquid and regenerating with water or methanol we obtained cellulose hydrogels and methanogels. The liquid mixtures were separated by vacuum distillation with high yield of recovery. The obtained gels were processed by supercritical carbon dioxide to give porous materials. A novel foaming procedure was applied to hydrogels in order to obtain microporous structures of cellulose and cellulose composites, while in alcogels the supercritical point drying method resulted in nanoporous aerogels. For elucidating physicochemical aspects involved in the two processes and for characterization of the produced materials, X-ray diffraction, sorption measurements (by a modified mass loss analysis and the BET method) and scanning electron microscopy were used. The role of various process parameters on the final porous structure was investigated.

No abstract

In the present study, an investigation of the mineralogy and morphology, the heavy metal content and the health risk of urban road dusts from the second largest city of Greece was conducted. For this reason road dust samples from selected sites within the city core area were collected. No differences were observed in the mineralogy of road dusts coming from different sampling sites, and they were mainly consisted of quartz and calcite, while an elevated amorphous content was detected. Morphologically road dusts presented Ca-rich, Fe-rich and silicates particles with various shapes and sizes. The mean concentrations of Cd, Cr, Cu, Mn, Ni, Pb and Zn in road dust were 1.76, 104.9, 662.3, 336.4, 89.43, 209 and 452.8 μg g, respectively. A series of spatial distribution patterns revealed that the hotspot areas were tended to associate with major road junctions and regions with high traffic. Combination of pollution indexes and statistical analyses (correlation analysis, cluster analysis and principal component analysis) revealed that road dusts have a severe influence by anthropogenic activities. In attempt to identify the source of metals through geostatistical and multivariate statistical analyses, it was concluded as follows: Cr, Cu, Fe and Zn mainly originated from tire/break wear and vehicle abrasions, while Cd, Mn and Pb were mainly related to fuel/oil leakage from automobiles along with oil lubricants and vehicle abrasion. Hazard quotient values for children based on total metal concentrations for the road dust ingestion route were lower than safe level (=1). However, the fact that the Hazard Index value for Pb (0.459) which is a particularly toxic metal, was close to safe level, renders essential further investigation in order to provide more reliable characterizations of potential health risks.

Mesoporous silica-based nanoparticles (MSNs) are considered promising drug carriers because of their ordered pore structure, which permits high drug loading and release capacity. The dissolution of Si and Ca from MSNs can trigger osteogenic differentiation of stem cells towards extracellular matrix calcification, while Mg and Sr constitute key elements of bone biology and metabolism. The aim of this study was the synthesis and characterization of sol–gel-derived MSNs co-doped with Ca, Mg and Sr. Their physico-chemical properties were investigated by X-ray diffraction (XRD), scanning electron microscopy with energy dispersive X-ray analysis (SEM/EDX), transmission electron microscopy (TEM), Fourier transform infrared spectroscopy (FTIR), X-ray fluorescence spectroscopy (XRF), Brunauer Emmett Teller and Brunauer Joyner Halenda (BET/BJH), dynamic light scattering (DLS) and ζ-potential measurements. Moxifloxacin loading and release profiles were assessed with high performance liquid chromatography (HPLC) cell viability on human periodontal ligament fibroblasts and their hemolytic activity in contact with human red blood cells (RBCs) at various concentrations were also investigated. Doped MSNs generally retained their textural characteristics, while different compositions affected particle size, hemolytic activity and moxifloxacin loading/release profiles. All co-doped MSNs revealed the formation of hydroxycarbonate apatite on their surface after immersion in simulated body fluid (SBF) and promoted mitochondrial activity and cell proliferation.

No abstract