No abstract

Spinstand level testing has demonstrated a failure mechanism that may go undetected using standard strain gage and acoustic emission methods of data capture. Since normally static friction is higher than dynamic friction, dynamic friction measurements are often ignored, filtered, or sampled at a much lower data rate than static friction measurements. In this study, dynamic friction peak values significantly higher than the static friction were recorded during take-off of Pico heads on laser-textured media. Furthermore, data collected using an optical surface analyzer (OSA) showed a greater degree of wear on disks exhibiting high dynamic friction. FFT was employed to analyze the signal modulation of the high dynamic friction event. Resonance at a frequency of approximately 1050 Hz was found to be associated with the high dynamic friction. Experiments were designed to reveal factors that influence this resonance occurrence. The factors identified that contribute to this resonance were natural frequency of the head load arm, disk bump pitch, and lubricant thickness. The head/disk interface system is believed to be excited by an improper bump pitch if the lubricant layer is not thick enough to reduce the friction value.

No abstract

Thermal asperities (TA’s) are tribological events that cause repercussions for giant magnetoresistance (GMR) and MR heads in the hard disk drive industry. A TA is a read signal spike caused by sensor temperature rise due to contact with disk asperities or contaminant particles. TA events may cause GMR and MR heads to temporarily lose their reading capability, and may potentially damage the transducer. It is difficult to completely avoid particle contamination in hard drive applications. Hence it is necessary to design heads/media with a minimum TA sensitivity to particles. A test method for TA sensitivity to particles is needed. This work developed a test method for TA sensitivities to particles. The test system includes a CSS tester with TA detection capability, a chamber to contain the head/disk interface, a particle atomizer, and a particle counter. Aluminum silicate particles used in the test have sizes ranging from 0.2 to 1.0 μm. Particles are injected into the chamber during head scan for TA’s from ID to OD with adjustable air-borne concentrations in the chamber from 10×106 to 30×106particles/m3. TA counts of 30 scans are averaged to obtain reliable TA sensitivity data. Media with different lubricant thickness, different carbon overcoats, and different lubricant types are tested with this method. The results indicated that this methodology can effectively differentiate TA sensitivity to particles for the media studied.