This paper investigated horizontal force production, foot kinematics, and metatarsophalangeal (MTP) joint push‐off axis use during acceleration in bend (anti‐clockwise) and straight‐line sprinting. It was hypothesized that bend sprinting would cause the left step push‐off to occur about the oblique axis, resulting in a decrease in propulsive force. Three‐dimensional kinematic and ground reaction force data were collected from nine participants during sprinting on the bend (36.5 m radius) and straight. Antero‐posterior force was reduced at 38%‐44% of stance during bend sprinting compared with the straight. This coincided with an increase in mediolateral force for the majority of the stance phase (3%‐96%) on the bend compared with the straight. In addition, a lower propulsive impulse was reported on the bend compared with the straight. Analysis of multi‐segment foot kinematics provides insight into the possible mechanisms behind these changes in force production. Mean mediolateral center of pressure position was more lateral in relation to the second metatarsal head in the left step on the bend compared with the straight, indicating the oblique axis was used for push‐off at the MTP joint. Greater peak joint angles of the left foot were also reported, in particular, an increase in left step midfoot eversion and internal ankle rotation. It is possible these changes in joint kinematics are associated with the observed decrease in propulsive force. Therefore, practitioners should seek to strengthen muscles such as tibialis posterior in frontal and sagittal planes and ensure specificity of training which may aid in addressing these force reductions.

Sprint velocity decreases on the bend when compared with the straight, therefore understanding technique during bend sprinting could have important implications for aiding race performance. Few bend sprinting studies have used optoelectronic cameras to investigate kinematic variables. Limited published evidence regarding the reliability of marker sets in conditions representative of elite bend sprinting makes model selection difficult. Therefore, a test-retest protocol was conducted to establish the reliability and minimum detectable difference of a lower limb and trunk marker set during bend sprinting (radius: 36.5 m). Six participants completed five, 60 m trials at maximum effort, with data collected at 38-45 m. This was repeated 2-7 days later. Spatio-temporal (e.g. contact time) and kinematic variables (e.g. peak joint angles) were evaluated. Intraclass correlation coefficients (ICC) were used to determine the between-and within-day reliability. Between-day reliability (ICC 3, k) was fair to excellent for all variables. Compared to between-day, within-day reliability demonstrated stronger agreement for the majority of variables. Thus, same-day data collection is preferable. It has been established that the marker set is reliable for future use. In addition, the minimal detectable difference was calculated which serves as useful reference for future research in bend sprinting. (Word count: 200)

A decrease in speed when sprinting on the bend compared with the straight has been attributed to kinetic, kinematic and spatiotemporal modifications. Although maximal speed is dependent on an athlete's ability to accelerate, there is limited research investigating the acceleration phase of bend sprinting. This study used a lower limb and trunk marker set with 15 optoelectronic cameras to examine kinematic and spatiotemporal variables of the lower limb during sprinting on the bend and straight.Nine sprinters completed up to six 30 m maximal effort trials in bend (radius 36.5 m, lane one) and straight conditions. An increase in body lateral lean at touchdown resulted in a number of asymmetric kinematic modifications. Whilst the left limb demonstrated a greater peak hip adduction, peak hip internal rotation and peak ankle eversion on the bend compared with the straight, the right limb was characterised by an increase in peak hip abduction. These results demonstrate that kinematic modifications start early in the race and likely accumulate, resulting in greater modifications at maximal speed. It is recommended that strength and conditioning programmes target the hip, ankle and foot in the non-sagittal planes. In addition, sprint training should prioritise specificity by occurring on the bend.

No abstract

Metatarsophalangeal joint push-off axis during sprinting on the bend and straight.