Purpose: Dental education institutions worldwide experienced disruptive changes amid the COVID-19 pandemic, with a rapid switch to the online learning format. Thus, this study aimed to assess the impact of the COVID-19 pandemic on dental education and evaluates the perceptions and attitudes of students towards the introduction of online learning in the School of Dental Medicine in Zagreb, Croatia. Methods: A survey was conducted on a population of undergraduate students. It was comprised of perceptions and attitudes of students on the impact of the COVID-19 pandemic on their psychoemotional status, changes introduced in the educational system, and online learning in particular. Results: Of the 352 students that completed the survey, 66.2% of students reported being psychoemotionally affected by the lockdown. The most significant impact of the switch from in-person to online learning was observed in terms of missing contact with lecturers (60.3%) and peers (90.3%) and loss of practical courses, regarding which 65% of students agreed that they could not be compensated. While only 36.1% reported that online teaching fully met their expectations, the majority of the students (61.9%) agreed that online lectures were as valuable as in-person lectures and that the theoretical courses could be carried out online in the future as well (69.9%). Conclusions: Students reported relative satisfaction with changes in the learning format and a positive attitude towards online learning; however, several challenges and obstacles were identified.

As future healthcare professionals, dental medicine students are expected to exhibit healthy lifestyle behaviors. This study aims to assess the health-promoting behaviors among undergraduate dental medicine students of all six academic study years at the University of Zagreb, and determine their predictors. Students were invited to complete a two-part survey, consisting of a self-reported sociodemographic questionnaire and the Health-Promoting Lifestyle Profile II (HPLP II). Three hundred and forty-nine students completed the survey; the response rate was 60.3%. The total mean HPLP II score was 2.64 ± 0.34. Students in the second academic study year scored the lowest (2.50 ± 0.33), and students in the sixth academic study year scored the highest (2.77 ± 0.32). Health responsibility was the overall lowest scored subcategory, while interpersonal relations was scored the highest. Female students reported lower spiritual growth and stress management than male students. Higher body mass index (BMI) was related to lower health responsibility. Smoking, place of residence and the age of participants did not seem to have an impact on health-promoting behaviors. Dental students at our faculty exhibit moderate health-promoting behaviors, even in the absence of a formal health-promoting course in the existing curriculum.

This study evaluated the flexural properties of an experimental composite series functionalized with 5–40 wt% of a low-Na F-containing bioactive glass (F-series) and compared it to another experimental composite series containing the same amounts of the conventional bioactive glass 45S5 (C-series). Flexural strength and modulus were evaluated using a three-point bending test. Degree of conversion was measured using Fourier-transform infrared spectroscopy. Weibull analysis was performed to evaluate material reliability. The control material with 0 wt% of bioactive glass demonstrated flexural strength values of 105.1–126.8 MPa). In the C-series, flexural strength ranged between 17.1 and 121.5 MPa and was considerably more diminished by the increasing amounts of bioactive glass than flexural strength in the F-series (83.8–130.2 MPa). Analogously, flexural modulus in the C-series (0.56–6.66 GPa) was more reduced by the increase in bioactive glass amount than in the F-series (5.24–7.56 GPa). The ISO-recommended “minimum acceptable” flexural strength for restorative resin composites of 80 MPa was achieved for all materials in the F-series, while in the C-series, the materials with higher bioactive glass amounts (20 and 40 wt%) failed to meet the requirement of 80 MPa. The degree of conversion in the F-series was statistically similar or higher compared to that of the control composite with no bioactive glass, while the C-series showed a declining degree of conversion with increasing bioactive glass amounts. In summary, the negative effect of the addition of bioactive glass on mechanical properties was notably less pronounced for the customized bioactive glass than for the bioactive glass 45S5; additionally, mechanical properties of the composites functionalized with the customized bioactive glass were significantly less diminished by artificial aging. Hence, the customized bioactive glass investigated in the present study represents a promising candidate for functionalizing ion-releasing resin composites.

No abstract