No abstract

No abstract

Corrosion resistance of sensitized austenitic stainless steel (SS) in chloride environments is currently the subject of numerous studies. Most of them are focused on neutral chloride solutions at room temperature and the experiments are carried out on ground stainless steels surfaces. This paper deals with the corrosion behavior of sensitized AISI 304 stainless steel in acid 1 M chloride solution (pH = 1.1) at the temperatures of 20 ± 3 °C and 50 °C. The specimens after sensitization are tested as covered by high-temperature surface oxides (“heat tinted”), and also after their chemical removal to assess the impact of the surface state on corrosion resistance. Potentiodynamic polarization (PP) and exposure immersion test are used as the independent corrosion tests. Microstructure before/after exposure immersion test is evaluated by optical microscopy (OM) and SEM. The results obtained showed that sensitization significantly conditions corrosion regardless of the removal of high-temperature oxides, and the elevated temperature mainly acts as its accelerating factor.

Plasma immersion ion implantation (PIII) of nitrogen is low-temperature surface technology which enables the improvement of tribological properties without a deterioration of the corrosion behavior of austenitic stainless steels. In this paper the corrosion properties of PIII-treated AISI 316L stainless steel surfaces are evaluated by electrochemical impedance spectroscopy (EIS), potentiodynamic polarization (PP) and exposure immersion tests (all carried out in the 0.9 wt. % NaCl solution at 37 ± 0.5 °C) and compared with a non-treated surface. Results of the three performed independent corrosion tests consistently confirmed a significant increase in the corrosion resistance after two doses of PIII nitriding.

This work deals with the study of polymers, and, in particular, polyethylene; its production, types, properties, and usage. The experimental part evaluates the changes of properties of the polyethylene film to be reused under various exposure conditions and selection of the most suitable medium for its application. The film made of low-density polyethylene (LD-PE) was influenced by aggressive media with different pH, specifically Savo for the disinfection, Savo as a Saponate for dish washing and Coca-Cola. On LD-PE films the water absorption and melting temperature evaluation tests were performed. Carried out tests show that the most aggressive medium for LD-PE film from used media is Coca-Cola. The most effective application of LD-PE film like wrapping on container transported is the Savo used as a Saponate for dish washing.