No abstract

Abstract. We compare two methods of calibrating the yaw response of hot-wire probes: (i) the assumption that an effective angle, independent of the flow speed, can be deduced; (ii) the more general approach of determining the yaw response at a number of different speeds. The first, simpler, approach is shown to give surprisingly reasonable results for the usual turbulence statistics, even in high turbulence intensity flows. Some differences in the distribution of the inclination of the instantaneous velocity vector are observed. There is no advantage in using the k 2 factor to allow for longitudinal cooling.

No abstract

Fluid dynamic forces in centrifugal blood pump impellers are of key importance in destruction of red blood cells (RBCs) because high rotational speed leads to strong interaction between the impeller and the RBCs. In this paper, three-dimensional models of five different blade geometries are investigated numerically using the commercial software CFX-TASCflow, and the streaklines of RBCs are obtained using the Lagrangian particle tracking method. In reality, RBCs pass through the pump along complicated paths resulting in a highly irregular loading condition for each RBC. In order to enable the prediction of blood damage under the action of these complex-loading conditions, a cumulative damage model for RBCs was adopted in this paper. The numerically simulated percent hemoglobin (%HB) released as RBCs traversed the impeller and volute was examined. It was observed that the residence time of particles in the blade passage is a critical factor in determining hemolytic effects. This, in turn, is a function of the blade geometry. In addition, it was observed that the volute profile is an important influence on the computed HB% released.

The axial blood pump with a magnetically suspended impeller is superior to other artificial blood pumps because of its small size. In this article, the distributions of velocity, path line, pressure, and shear stress in the straightener, the rotor, and the diffuser of the axial blood pump, as well as the gap zone were obtained using the commercial software, Fluent (version 6.2). The main focus was on the flow field of the blood pump. The numerical results showed that the axial blood pump could produce 5.14 L/min of blood at 100 mm Hg through the outlet when rotating at 11,000 rpm. However, there was a leakage flow of 1.06 L/min in the gap between the rotor cylinder and the pump housing, and thus the overall flow rate the impeller could generate was 6.2 L/min. The numerical results showed that 75% of the scalar shear stresses (SSs) were less than 250 Pa, and 10% were higher than 500 Pa within the whole pump. The high SS region appeared around the blade tip where a large variation of velocity direction and magnitude was found, which might be due to the steep angle variation at the blade tip. Because the exposure time of the blood cell at the high SS region within the pump was relatively short, it might not cause serious damage to the blood cells, but the improvement of blade profile should be considered in the future design of the axial pump.