Dual optical frequency combs are an appealing solution to many optical measurement techniques due to their high spectral and temporal resolution, high scanning speed, and lack of moving parts. However, industrial and field-deployable applications of such systems are limited due to a high-cost factor and intricacy in the experimental setups, which typically require a pair of locked femtosecond lasers. Here, we demonstrate a single oscillator which produces two mode-locked output beams with a stable repetition rate difference. We achieve this via inserting two 45°-cut birefringent crystals into the laser cavity, which introduces a repetition rate difference between the two polarization states of the cavity. To mode-lock both combs simultaneously, we use a semiconductor saturable absorber mirror (SESAM). We achieve two simultaneously operating combs at 1050 nm with 175-fs duration, 3.2-nJ pulses and an average power of 440 mW in each beam. The average repetition rate is 137 MHz, and we set the repetition rate difference to 1 kHz. This laser system, which is the first SESAM mode-locked femtosecond solid-state dual-comb source based on birefringent multiplexing, paves the way for portable and high-power femtosecond dual-combs with flexible repetition rate. To demonstrate the utility of the laser for applications, we perform asynchronous optical sampling (ASOPS) on semiconductor thin-film structures with the free-running laser system, revealing temporal dynamics from femtosecond to nanosecond time scales.

Quantum cascade detectors (QCD) are photovoltaic mid-infrared detectors based on intersubband transitions. Owing to the sub-picosecond carrier transport between subbands and the absence of a bias voltage, QCDs are ideally suited for high-speed and room temperature operation. Here, we demonstrate the design, fabrication, and characterization of 4.3 µm wavelength QCDs optimized for large electrical bandwidth. The detector signal is extracted via a tapered coplanar waveguide (CPW), which was impedance-matched to 50 Ω. Using femtosecond pulses generated by a mid-infrared optical parametric oscillator (OPO), we show that the impulse response of the fully packaged QCDs has a full-width at half-maximum of only 13.4 ps corresponding to a 3-dB bandwidth of more than 20 GHz. Considerable detection capability beyond the 3-dB bandwidth is reported up to at least 50 GHz, which allows us to measure more than 600 harmonics of the OPO repetition frequency reaching 38 dB signal-to-noise ratio without the need of electronic amplification.

A simple and compact straight-cavity laser oscillator incorporating a cascaded quadratic nonlinear crystal and a semiconductor saturable absorber mirror (SESAM) can deliver stable femtosecond modelocking at high pulse repetition rates >10 GHz. In this paper, we experimentally investigate the influence of intracavity dispersion, pump brightness, and cavity design on modelocking with high repetition rates, and use the resulting insights to demonstrate a 10.4-GHz straight-cavity SESAM-modelocked Yb:CALGO laser delivering 108-fs pulses with 812 mW of average output power. This result represents a record-level performance for diode-pumped femtosecond oscillators with repetition rates above 10 GHz. Using the oscillator output without any optical amplification, we demonstrate coherent octave-spanning supercontinuum generation (SCG) in a silicon nitride waveguide. Subsequent f-to-2f interferometry with a periodically poled lithium niobate waveguide enables the detection of a strong carrier-envelope offset (CEO) beat note with a 33-dB signal-to-noise ratio.

No abstract

We use two chip-scale waveguide platforms for self-referenced carrier-envelope offset frequency detection of a 10-GHz modelocked laser. A tunable beat note with a 33-dB signal-to-noise ratio is generated with only 18-pJ of coupled pulse energy.