No abstract

Closely-spaced outburst coal seams (COCS) is the main condition of coal seams in southwest China, and gas disasters are one of the major problems affecting coal mine safety. Mining a protective seam and pre gas extraction are the most safety way to improve the efficiency of mining under these conditions. However, low pre-mining gas extraction efficiency coupled with the close proximity of adjacent working faces is a problem. When mining at an old working face has been completed but the new working face is not yet ready to be mined, coal-bed gasses can flow into the new working face from adjacent seams and this commonly causes methane monitoring instruments to sound an alarm. These gas extraction difficulties lead to a conflict between mine safety and profit. To solve these problems, a sequential approach for integrated coal and gas mining of closely-spaced outburst coal seams is introduced in this paper. Two fundamental principles are proposed: (1) Fully coordinating the spatiotemporal relationships between gas extraction, roadway development, and coal mining to maximize both mine safety and coal and gas production; (2) Defining a mining sequence for outburst coal seams and choosing the coal seam with the weakest outburst risk as the protective seam. A system for comprehensive gas extraction in underground coal mines is divided into four stages for gas extraction: gas extraction before coal roadway tunneling, gas extraction before coal mining, gas extraction during coal mining, and gas extraction from the goaf after coal mining. The Songzao mining area, China, is used as a case study to demonstrate the effectiveness of this model, and it brings three major benefits: it improves underground coal mine safety with physical gas accidents decreased by 66.8%, it makes underground coal-bed methane (CBM) extraction more efficient with the average gas extraction rate were respectively 45.13 m3/t and 62.4%, the highest in China, and it reduces greenhouse gas emissions equivalent to 3.5 million tonnes of carbon dioxide. This study could be used as a valuable example for other coal deposits being mined under similar geological conditions.

When drilling coal-bearing sequences to enhance coal seam permeability by hydraulic fracturing (HF), the location where fractures are initiated is important. To date, most research on fracture initiation has studied the problem in two dimensions. In this study, a three-dimensional model to assess initiation location is developed. The model analyzes the stress state of both the borehole wall and the coal-rock interface and the model shows that the fracture initiation location is affected by in situ stress, the dip of the coal seam, and the angle between the borehole and the coal seam. How the initiation location changes near different types of geological faults is calculated by assuming typical in situ stresses for the faults. Following these calculations, physical experiments were carried out to emulate cross-measure hydraulic fracturing under stress conditions equivalent to those in the Chongqing Tonghua coal mine, China. Fracture initiation during the experiments was monitored by an acoustic emission system. The experimental results were consistent with the theoretical calculations. This implies that the three-dimensional model for assessing the locations of fracture initiation can be applied to forecast the initiation location of fractures generated by cross-measure drilling. The assessment model provides reference values for this type of drilling in underground mines.

The ionospheric effect breaks the correlation of carrier phases between dual sidebands of binary offset carrier (BOC) signal. Thus conventional sideband processing algorithms usually perform non-coherent combination of the dual sidebands, which degrades the tracking accuracy and sensitivity. In order to improve the accuracy, this paper proposes a computationallyeffective tracking algorithm that involves coherent combination of BOC dual sidebands. The tracking loop of the proposed algorithm includes a novel design of a subcarrier discriminator using the differential carrier phase of dual sidebands. Simulation results show that proposed algorithm achieves simultaneous high precision and low computational complexity for high-order BOC.