No abstract

No abstract

The poly(methyl methacrylate/butyl acrylate/acrylic acid) [P(MMA/BA/AA)] and poly (styrene/ butyl acrylate/acrylic acid) [P(St/BA/AA)] latexes were synthesized using the emulsifier octylphenol polyoxyethylene(10) ether (OP-10) and ammonium sulfate allyloxy nonylphenoxy poly(ethyleneoxy)(10) ether(DNS-86). The optimum amount of OP-10 and DNS-86 was 1.5% and 2.5% respectively. The P(MMA/BA/AA) and P(St/BA/AA) latex containing 1.5% OP-10 or 2.5% DNS-86 were blended pairwise. The performances of latex blends and parent latexes as a function of emulsifiers content in parent latexes were determined. The results indicated that the stability of latex blends is favorable, and particle size distribution was more uniform and thermal stability was improved after blending.

A series of waterborne epoxy latexes was synthesized, and epoxy/(silica sol) composite latexes were prepared. The effects of functional monomer methacrylic acid (MAA) and silica sol on the latex particle size, morphology, and stability were investigated. With increasing amounts of MAA, the conversion rate increased, the particle size reduced, and the viscosity of the epoxy latexes increased. The epoxy latexes had storage stability and could be stored at room temperature for more than 6 months with a solid content variation of less than 1%. For the (silica sol)‐modified waterborne epoxy latexes, the effects of preparation techniques and silica sol content on the latexes and latex films were investigated. When the silica sol content increased, the particle size of the composite latexes decreased. The morphology investigation showed that when the silica sol content increased, the uneven surface level of the latex films was increased. The increase of elemental silica on the surface was in accord with the improvement of the water resistance of the composite latex films. The heat resistance of these films was improved as well, and their overall performance was better than that of the epoxy latex films. J. VINYL ADDIT. TECHNOL., 20:57–64, 2014. © 2014 Society of Plastics Engineers