No abstract

The rupture of coal pillar can lead to spontaneous combustion or collapse of goaf, which endangers the safety of workers. To explore the relationship between the crack depth of the coal structure and the signal received by the piezoelectric ceramic sensor, the output data of coal samples were analyzed by using the piezoelectric effect, combined with the experiment and ABAQUS simulation. Based on the signal amplitude, the output signal characteristics of the coal model with different crack depths were analyzed, and the evaluation index of coal crack cracking degree (Dc) was defined. The results show that the piezoelectric fluctuation method can effectively identify the local cracks of coal. When the distance between the lead Piezoelectric Transducer (PZT) patch and crack position is constant, the amplitude of the PZT patch output signal will decay with the deepening of the crack depth, while the value of increases with the increase of crack depth. This study provides a theoretical basis for mine disaster prevention and control.

An explosion with a discontinuous gas supply (DGS-explosion) is more complicated than a common secondary explosion. We present the results of a study on the propagation laws of the DGS-explosion induced by a gas explosion in excavation roadways. A rectangular tube was established using ANSYS, similar to an excavation roadway in an underground coal mine. The gas, flame, and shock wave propagation laws were determined by analyzing the explosive gas as it exited the excavation roadway. The results show that the initial explosion caused the flame generated in the DGS-explosion to be significantly stretched. Moreover, the shock wave was reflected by the end of the tube, which resulted in the reverse migration of the local gas after the DGS-explosion. Meanwhile, with the increase in local gas concentrations, the pressure peak and the entire explosion system can increase after the DGS-explosion. The flame region, temperature peak, and flame irregularity in the tube positively correlate with the concentration. These results can provide theoretical support and an experimental basis for preventing and responding to accidents caused by gas explosion accidents.

Timber linings are applied as primary supports in the tunnel fault and fracture zones of mines. These linings are essential to prevent broken rock from falling during the occurrence of exogenous fires. In this study, experiments and numerical simulations were carried out using a fire dynamics simulator to investigate the flame-spread rate, flame characteristics, smoke movement, and spread process of timber-lining fires under different wind speeds of 0, 0.25, 0.5, and 0.75 m/s. It was found that cross-section flame spreading follows the three-stage sidewall-ceiling-sidewall pattern. Moreover, the average flame-spread rate increases along the vertical flame-spreading direction and decreases when the flame reaches the timber-lining corners. Moreover, the flame lengths underneath the timber-lining ceiling in the x-direction are longer than those in the y-direction. As the wind speed increases, the normalized flame lengths R(f) in the two directions decrease, and the maximum temperature underneath the ceiling decreases. In addition, the maximum temperature in the three tunnel sections of interest is first recorded in the tunnel cross-section in the initial fire stage. Higher wind speeds correspond to farther distances of the maximum-temperature points of the three timber-lining sections from the fire source.