Supramolecular elastomers obtained through a two-step reaction of linear carboxyl-terminated polydimethylsiloxane oligomers (PDMS–COOH2) with diethylenetriamine (DETA) and urea show reasonable hysteresis and acceptable self-healing properties.

Novel self-healing supramolecular elastomers based on polydimethylsiloxanes (SESi) were synthesized from a mixture of polydimethylsiloxanes derivers with single, di-, or tri-carboxylic acid groups (PDMS-COOH x , where x ¼ 1, 2, and 3, respectively), diethylene triamine, and urea with a two-stage procedure. The reactions and the final products were tracked, characterized, and confirmed by Fourier transform infrared spectroscopy, 1 H-NMR, differential scanning calorimetry, dynamic mechanical analysis, and gel permeation chromatography. Compared with a supramolecular rubber based on dimer acid (reported previously) with a similar synthesis procedure, the SESi showed a lower glass-transition temperature of about À113 C for the softer chain of polydimethylsiloxane and showed real rubberlike elastic behavior and self-healing properties at room temperature or even lower temperatures.

No abstract

Polyimide film, as a special type of engineering plastic film, is a kind of basic insulating material and is widely applied in the aerial, nuclear, microelectronic industry, turn to turn insulation and turn to ground insulation of inverter-fed motors. However, with the disadvantage of organic polymer, its corona-resistance property is not good enough, which makes insulation early failures occur frequently. The existence of surface charge has a great effect on breakdown characteristic and is the main reason leading to dielectric breakdown. Fluorination as change the chemical component in surface layer of polymers should give rise to the corresponding change in electrical properties of the surface layer thus influence the charge injection from electrodes when they are used as an insulator. This paper presents a study aimed at clarifying the effect of fluorination time on surface charge accumulation and decay behaviors of fluorinated polyimide film. Samples were surface fluorinated in a laboratory vessel at about 328K (55 ℃) using a F 2 /N 2 mixture with 20% F 2 by volume and 0.05 MPa (500 mbar) for respectively 15, 30, 45 and 60 minutes. Corona charging tests were performed at room temperature with a relative humidity of ~ 40%. The charge distribution was measured by means of an electrostatic voltmeter. Obtained results show the dependence of the charge density as well as the charge decay rate upon the fluorination time of samples, varying as a function of the charge polarity and charging time.

A two-dimensional (2D) fluid model is presented to investigate the spatiotemporal generation and dynamic mechanics of dielectric barrier columnar discharges in atmospheric helium. The model was examined with discharge currents measured in experiments and images taken by an intensified charge couple device camera. Based on the model, a columnar discharge was simulated for several cycles after being ignited. The discharge could be regarded as an initial unstable stage for the first three and a half cycles, then a steady state for the following cycles. In the initial stage, the discharge evolves from a uniform pattern into a columnar one. The calculated equipotential lines, 2D radial electric field, and electron density distributions at the edge of uniform discharges show the radial electric field accounts for the shrinking discharge area and the formation of discharge columns in the end. The columnar glow discharges and the Townsend discharges beyond the columns could coexist in the initial stage, and a Townsend discharge might develop into a new glow column in the next half-cycle. The radial electric field surrounding a glow discharge column has an inhibiting effect on the ionization in the peripheral area.