In recent decades, significant advances in drug‐delivery systems have enabled more effective drug administration. To deliver drugs to specific organs, a range of organic systems (e.g., micelles, liposomes, and polymeric nanoparticles) have been designed. They suffer from limitations, including poor thermal and chemical stability, and rapid elimination by the immune system. In contrast, silica particles offer a biocompatible, stable, and “stealthy” alternative. Bioactive molecules can be easily encapsulated within silica particles by combining sol–gel polymerization with either spray‐drying or emulsion chemistry. Spray‐drying faces challenges, including low yield, surface segregation, and size limitations. In contrast, sol–gel emulsions enable the production of nanoparticles with homogeneous drug distribution, and permit ambient temperature processing, necessary for handling biologicals. Independent control of the size and release rate can be readily achieved. Preliminary in‐vivo experiments reveal enhanced blood stability of the nanoparticles, which, coupled with sustained release of anti‐tumor agents, show good potential for cancer treatment.

Silica nanoparticles for controlled release applications have been produced by the reaction of tetramethylorthosilicate (TMOS) inside the water droplets of a water-in-oil microemulsion, under both acidic (pH 1.05) and basic (pH 10.85) conditions. In-situ FTIR measurements show that the addition of TMOS to the microemulsion results in the formation of silica as TMOS, preferentially located in the oil phase, diffuses into the water droplets. Once in the hydrophilic domain, hydrolysis occurs rapidly as a result of the high local concentration of water. Varying the pH of the water droplets from 1.05 to 10.85, however, considerably slows the hydrolysis reaction of TMOS. The formation of a dense silica network occurs rapidly under basic conditions, with IR indicating the slower formation of more disordered silica in acid. SAXS analysis of the evolving particles shows that approximately 11 nm spheres are formed under basic conditions; these are stabilized by a water/surfactant layer on the particle surface during formation. Under acidic conditions, highly uniform approximately 5 nm spheres are formed, which appear to be retained within the water droplets (approximately 6 nm diameter) and form an ordered micelle nanoparticle structure that exhibits sufficient longer-range order to generate a peak in the scattering at q approximately equal to 0.05 A-1. Nitrogen adsorption analysis reveals that high surface area (510 m2/g) particles with an average pore size of 1 nm are formed at pH 1.05. In contrast, base synthesis results in low surface area particles with negligible internal porosity.

Lanthanum zirconate has been prepared via a new chemical synthesis method by combining sol-gel processing and complex precipitation. The synthesis was carried out in aqueous solution under ambient conditions. The synthesized powder possessed the pyrochlore superstructure upon calcination above 1200°C. A suite of characterization techniques, including FTIR, Raman, X-ray and electron diffraction, TEM, SEM, and nitrogen sorption were employed to investigate the microstructural evolution and bulk properties. Dense ceramics (>90% relative density) were obtained after sintering at 1400°C, without need for additional processing (i.e., hot or cold isostatic pressing) or any milling steps. A mechanism has been proposed that elucidates molecular assembly of this chemical synthesis method.

No abstract

Cerium titanate CeTi2O6 was prepared by a new soft chemistry route in aqueous solution. A suite of characterization techniques, including X-ray diffraction, thermal analysis, vibrational spectroscopy, and scanning and transmission electron spectroscopy, were employed to investigate the brannerite structure formation and its bulk properties. The synthesized powder formed the brannerite crystal structure upon calcination at temperatures as low as 800 °C. Samples sintered at 1350 °C possess a high level of crystallinity. X-ray absorption near-edge structure results indicate the presence of six-coordinated Ce(4+) in the brannerite samples.