No abstract

Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention baseband processing complexity. However, most hybrid precoding techniques consider a fully-connected architecture requiring a large number of phase shifters, which is also energyintensive. In this paper, we focus on the more energy-efficient hybrid precoding with sub-connected architecture, and propose a successive interference cancelation (SIC)-based hybrid precoding with near-optimal performance and low complexity. Inspired by the idea of SIC for multi-user signal detection, we first propose to decompose the total achievable rate optimization problem with non-convex constraints into a series of simple sub-rate optimization problems, each of which only considers one sub-antenna array. Then, we prove that maximizing the achievable sub-rate of each sub-antenna array is equivalent to simply seeking a precoding vector sufficiently close (in terms of Euclidean distance) to the unconstrained optimal solution. Finally, we propose a low-complexity algorithm to realize SICbased hybrid precoding, which can avoid the need for the singular value decomposition (SVD) and matrix inversion. Complexity evaluation shows that the complexity of SIC-based hybrid precoding is only about 10% as complex as that of the recently proposed spatially sparse precoding in typical mmWave MIMO systems. Simulation results verify the near-optimal performance of SIC-based hybrid precoding.Index Terms-MIMO, mmWave communications, hybrid precoding, energy-efficient, 5G.

Abstract-In the 5th generation (5G) of wireless communication systems, hitherto unprecedented requirements are expected to be satisfied. As one of the promising techniques of addressing these challenges, non-orthogonal multiple access (NOMA) has been actively investigated in recent years. In contrast to the family of conventional orthogonal multiple access (OMA) schemes, the key distinguishing feature of NOMA is to support a higher number of users than the number of orthogonal resource slots with the aid of non-orthogonal resource allocation. This may be realized by the sophisticated inter-user interference cancellation at the cost of an increased receiver complexity. In this article, we provide a comprehensive survey of the original birth, the most recent development, and the future research directions of NOMA. Specifically, the basic principle of NOMA will be introduced at first, with the comparison between NOMA and OMA especially from the perspective of information theory. Then, the prominent NOMA schemes are discussed by dividing them into two categories, namely, power-domain and code-domain NOMA. Their design principles and key features will be discussed in detail, and a systematic comparison of these NOMA schemes will be summarized in terms of their spectral efficiency, system performance, receiver complexity, etc. Finally, we will highlight a range of challenging open problems that should be solved for NOMA, along with corresponding opportunities and future research trends to address these challenges.

Abstract-Millimeter wave (mmWave) communications have recently attracted large research interest, since the huge available bandwidth can potentially lead to rates of multiple Gbps (gigabit per second) per user. Though mmWave can be readily used in stationary scenarios such as indoor hotspots or backhaul, it is challenging to use mmWave in mobile networks, where the transmitting/receiving nodes may be moving, channels may have a complicated structure, and the coordination among multiple nodes is difficult. To fully exploit the high potential rates of mmWave in mobile networks, lots of technical problems must be addressed. This paper presents a comprehensive survey of mmWave communications for future mobile networks (5G and beyond). We first summarize the recent channel measurement campaigns and modeling results. Then, we discuss in detail recent progresses in multiple input multiple output (MIMO) transceiver design for mmWave communications. After that, we provide an overview of the solution for multiple access and backhauling, followed by analysis of coverage and connectivity. Finally, the progresses in the standardization and deployment of mmWave for mobile networks are discussed.

Abstract-The recent concept of beamspace multiple input multiple output (MIMO) can significantly reduce the number of required radio-frequency (RF) chains in millimeter-wave (mmWave) massive MIMO systems without obvious performance loss. However, the fundamental limit of existing beamspace MIMO is that, the number of supported users cannot be larger than the number of RF chains at the same time-frequency resources. To break this fundamental limit, in this paper we propose a new spectrum and energy efficient mmWave transmission scheme that integrates the concept of non-orthogonal multiple access (NOMA) with beamspace MIMO, i.e., beamspace MIMO-NOMA. By using NOMA in beamspace MIMO systems, the number of supported users can be larger than the number of RF chains at the same time-frequency resources. Particularly, the achievable sum rate of the proposed beamspace MIMO-NOMA in a typical mmWave channel model is analyzed, which shows an obvious performance gain compared with the existing beamspace MIMO. Then, a precoding scheme based on the principle of zeroforcing (ZF) is designed to reduce the inter-beam interferences in the beamspace MIMO-NOMA system. Furthermore, to maximize the achievable sum rate, a dynamic power allocation is proposed by solving the joint power optimization problem, which not only includes the intra-beam power optimization, but also considers the inter-beam power optimization. Finally, an iterative optimization algorithm with low complexity is developed to realize the dynamic power allocation. Simulation results show that the proposed beamspace MIMO-NOMA can achieve higher spectrum and energy efficiency compared with existing beamspace MIMO.