Active matrix, flat-panel imagers (AMFPIs) suffer from decreased detective quantum efficiency under conditions of low dose per image frame (such as for digital breast tomosynthesis, fluoroscopy and cone-beam CT) due to low signal compared to the additive electronic noise. One way to address this challenge is to introduce a high-gain x-ray converter called particle-in-binder mercuric iodide (PIB HgI2) which exhibits 3–10 times higher x-ray sensitivity compared to that of a-Se and CsI:Tl converters employed in commercial AMFPI systems. However, a remaining challenge for practical implementation of PIB HgI2 is the high level of image lag, which is believed to largely originate from the trapping of holes. Towards addressing this challenge, this paper reports a theoretical investigation of the use of a Frisch grid structure embedded in the converter to suppress hole signal—which would be expected to reduce image lag. The grid acts as a third electrode sandwiched between a continuous top electrode and pixelated bottom electrodes having a 100 μm pitch. Signal properties of such a detector are investigated as a function of VDR (the ratio of the voltage difference between the electrodes in the region below the grid to that above the grid), grid pitch (the center-to-center distance between two neighboring grid wires) and R GRID (the ratio of grid wire width to grid pitch) for mammographic x-ray energies. The results show that smaller grid pitch suppresses hole signal to a higher degree (up to ∼96%) while a larger gap between grid wires and higher VDR provide minimally impeded electron transport. Examination of the tradeoff between maximizing electron signal and minimizing hole signal indicates that a grid design having a grid pitch of 20 μm with R GRID of 50% and 65% provides hole signal suppression of ∼93% and ∼95% for VDR of 1 and 3, respectively.

No abstract

No abstract

No abstract