Aim: The aim of this study was to evaluate the surface roughness and the color stability of nanocomposite exposed to the sodium bicarbonate air-polishing (SBAP) followed by red wine, coffee and cigarette smoke exposure. Materials and Methods: 64 nanocomposite specimens were prepared and allocated in 8 groups: G1 (SBAP + distilled water), G2 (SBAP + coffee), G3 (SBAP + red wine), G4 (SBAP + cigarette smoke), G5 (distilled water), G6 (coffee), G7 (red wine) and G8 (cigarette smoke). The surface roughness was evaluated in three periods: before and after SBAP and after exposuring to agents tested. The color was evaluated according to CIEL*a*b* parameters using reflection spectrophotometer in two moments: initial and 30 days after the exposure to staining agents. Data were subjected to three-way repeated measures ANOVA and Tukey's test (5%). Results: The results showed a higher surface roughness of the nanocomposite submitted only to the SBAP and those exposed to the SBAP followed by exposure to the coffee or wine solution. The previous application of SBAP followed by cigarette smoke exposure did not increase the roughness of nanocomposite. The SBAP procedure just increased the staining for cigarette smoke group. Conclusion: The SBAP increases resin surface roughness, which worsens when there is exposure to coffee and red wine solution. In addition, SBAP may also provide increased staining of nanocomposites exposed to cigarette smoke.

Aim. To evaluate the effect of cigarette smoke on water sorption and solubility of four adhesive systems. Materials and Methods. Sixteen disks of each adhesive system were prepared (Adper Scotchbond Multipurpose Adhesive (SA); Adper Scotchbond Multipurpose Adhesive System (Adhesive + Primer) (SAP); Adper Single Bond Plus (SB); Adper Easy One (EO)). Specimens were desiccated until a constant mass was obtained and divided into two groups (n = 8). One-half of the specimens were immersed in deionized water, while the other half were also immersed, but with daily exposure to tobacco smoke. After 21 days, disks were measured again and stored in desiccators until constant mass was achieved. Data were calculated according to ISO specifications and statistically analyzed. Results. The tobacco smoke only significantly affected the water sorption and solubility of EO. There were significant differences in both analyses among materials tested. The SB exhibited the highest water sorption, followed by EO, which demonstrated significantly higher solubility values than SB. The SA and SAP showed low water sorption and solubility, and there were no significant differences between the two. Conclusion. Regardless of smoke exposure, both simplified adhesive systems presented an inferior performance that could be related to the complex mixture of components in such versions.

No abstract

No abstract

No abstract