No abstract

The Brillouin optical time-domain reflectometer (BOTDR) system, which is based on the Brillouin frequency shift (BFS) of the scattering spectrum, has been widely applied to monitor the temperature and strain in many fields. The measurement accuracy of the BFS directly affects the monitoring and location of the temperature change or strain events. In this study, the characteristics of the least-squares fitting optimal solution of the Brillouin power spectrum are theoretically investigated, and a half-peak fitting algorithm is proposed to measure the BFS with high accuracy and stability. In particular, it can precisely determine the double-peak spectrum and detect the position in the transition section of a temperature change or strain event. Furthermore, it can reduce calculation complexity and enhance measurement speed by dropping most of the data. For the fiber under test (FUT) with a length of 12-km, 200 groups of time-domain data were processed using a probe pulse of width 50 ns and sampling rate 1 GHz. The half-peak fitting algorithm increased the temperature measurement accuracy by ~1 fold, with ~20% calculation of full fitting. Meanwhile, it effectively eliminated the influence of minor peak in the doublepeak spectrum, and optimized the spatial resolution of the temperature change position to 0.1-m, which is the maximum limitation by sampling rate.

Nonlinear frequency division multiplexing (NFDM) system is an optional candidate to overcome the fiber nonlinearity limit. A full-spectrum modulated NFDM system, modulating data on combined continuous spectrum (CS) and discrete spectrum (DS) together, was proposed in recent years to improve the data rates and spectral efficiency (SE) by exploiting all the degrees of freedom offered in the nonlinear spectrum. However, the selection of discrete eigenvalues greatly affects the performance of both CS and DS. Designing appropriate eigenvalues of DS is an important issue to ensure the high SE and excellent performance of the system. In this paper, we discussed the selcection principle of eigenvalues and analyzed it from multiple perspectives, 11 eigenvalues with 64-quadrature amplitude modulation (64QAM) are selected for DS. Besides optimizing the eigenvalues at the transmitter, the linear minimum mean-square estimate (LMMSE) method was used at the receiver to furtherly improve the performance of DS. Through the numerical simulation, a 113 Gb/s (SE of 2.8 bits/s/Hz) full-spectrum modulated NFDM system was set up and transmitted 1120 km distance, where the Q-factors of both CS and DS are above the hard-decision forward error correction (HD-FEC) threshold. The results provide a way to design an efficiently full-spectrum modulated NFDM system.