Spatially and temporally resolved digital particle image velocimetry measurements are presented of flow complexities in a nominally two-dimensional, symmetric, duct with an oscillating constriction. The motivation for this research lies in advancing the state-of-the-art in applying integral control volume analysis to modeling unsteady internal flows. The specific target is acoustic modeling of human phonation. The integral mass and momentum equations are directly coupled to the acoustic equations and provide quantitative insight into acoustic source strengths in addition to the dynamics of the fluid-structure interactions in the glottis. In this study, a square cross-section duct was constructed with symmetric, computer controlled, oscillating constrictions that incorporate both rocking as well as oscillatory open/close motions. Experiments were run in a free-surface water tunnel over a Strouhal number range, based on maximum jet speed and model length, of 0.012-0.048, for a fixed Reynolds number, based on maximum gap opening and maximum jet speed, of 8000. In this study, the constriction motions were continuous with one open-close cycle immediately following another. While the model and its motions were nominally two-dimensional and symmetric, flow asymmetries and oscillation frequency dependent cycle-to-cycle variations were observed. These are examined in the context of terms in the integral conservation equations.

This paper presents micro-particle tracking velocimetry measurements over cultured bovine aortic endothelial cell monolayers in microchannels. The objective was to quantify fluid forces and cell morphology at the sub-cellular scale for monolayers subjected to steady shear rates of 5, 10, and 20 dyn/cm 2. The ultimate goal of this study was to develop an experimental methodology for in vitro detailed study of physiologically realistic healthy and diseased conditions. Cell topography, shear stress, and pressure distributions were calculated from sets of velocity fields made in planes parallel to the microchannel wall. For each experiment, measurements were made in 3 h intervals for 18 h. It was found that there is a three-dimensional change in cell morphology as a result of applied shear stress. That is, cells flatten and become more wedge shaped in the stream direction while conserving volume by spreading laterally, i.e., in the cross-stream direction. These changes in cell morphology are directly related to local variations in fluid loading, i.e., shear stress and pressure. This paper describes the first flow measurements over a confluent layer of endothelial cells that are spatially resolved at the sub-cellular scale with a simultaneous temporal resolution to quantify the response of cells to fluid loading.