Applications of REBCO coated conductors are now being developed for a very wide range of temperatures and magnetic fields and it is not yet clear whether vortex pinning strategies aimed for high temperature, low field operation are equally valid at lower temperatures and higher fields. A detailed characterization of the superconducting properties of a 15 mol. % Zr-added REBCO thin film made by metal organic chemical vapor deposition, from 4.2 to 77 K under magnetic fields up to 31 T is presented in this article. Even at a such high level of Zr addition, Tc depression has been avoided (Tc = 91 K), while at the same time an exceptionally high irreversibility field Hirr ≈ 14.8 T at 77 K and a remarkably high vortex pinning force density Fp ≈ 1.7 TN/m3 at 4.2 K have been achieved. We ascribe the excellent pinning performance at high temperatures to the high density (equivalent vortex matching field ∼7 T) of self-assembled BZO nanorods, while the low temperature pinning force is enhanced by large additional pinning which we ascribe to strain-induced point defects induced in the REBCO matrix by the BZO nanorods. Our results suggest even more room for further performance enhancement of commercial REBCO coated conductors and point the way to REBCO coil applications at liquid nitrogen temperatures since the critical current density Jc(H//c) characteristic at 77 K are now almost identical to those of fully optimized Nb-Ti at 4 K.

REBa2Cu3Ox ((REBCO), RE = rare earth) superconductor tapes with moderate levels of dopants have been optimized for high critical current density in low magnetic fields at 77 K, but they do not exhibit exemplary performance in conditions of interest for practical applications, i.e., temperatures less than 50 K and fields of 2–30 T. Heavy doping of REBCO tapes has been avoided by researchers thus far due to deterioration in properties. Here, we report achievement of critical current densities (Jc) above 20 MA/cm2 at 30 K, 3 T in heavily doped (25 mol. % Zr-added) (Gd,Y)Ba2Cu3Ox superconductor tapes, which is more than three times higher than the Jc typically obtained in moderately doped tapes. Pinning force levels above 1000 GN/m3 have also been attained at 20 K. A composition map of lift factor in Jc (ratio of Jc at 30 K, 3 T to the Jc at 77 K, 0 T) has been developed which reveals the optimum film composition to obtain lift factors above six, which is thrice the typical value. A highly c-axis aligned BaZrO3 (BZO) nanocolumn defect density of nearly 7 × 1011 cm−2 as well as 2–3 nm sized particles rich in Cu and Zr have been found in the high Jc films.

We have conducted a critical current density Jc(T, H) study over a wide temperature T from 77 down to 20 K and a magnetic field H up to 9 T on more than 50 ∼ 0.9 μm-thick REBa2Cu3O7−δ (RE = rare earth) thin films containing different concentrations of BaZrO3 (BZO). We found that, independent of the composition, there is a linear correlation between Jc(77 K, 3 T||c) and Jc(T, H||c) at T down to 20 K and H up to 9 T. Moreover, Jc(77 K, 3 T||c) is also linearly correlated to Jc(T, H||ab) below 40 K. We ascribed this linear correlation to the dominant pinning source of BZO nanorods, which act as a strong correlated pinning at T above ∼30 K and provide weak uncorrelated point pins at lower temperatures. Our result emphasizes that Jc(77 K, 3 T||c) is a key metric for metal-organic chemical vapor deposited REBa2Cu3O7−δ coated conductors.

The effect of high temperature superconductor (HTS) film composition on the adhesion strength of rare-earth barium copper oxide coated conductors (CCs) has been studied. It has been found that the mechanical integrity of the superconductor layer is very susceptible to the defects especially those along the ab plane, probably due to the weak interfaces between the defects and the matrix. Gd and Y in the standard composition were substituted with Sm and the number of in-plane defects was drastically reduced. Consequently, a four-fold increase in adhesion or peeling strength in Sm-based CCs was achieved compared to the standard GdYBCO samples.

No abstract