In order to use bovine dentin instead of human dentin for in vitro adhesion and cytotoxicity tests the permeability characteristics of human and bovine dentin should be similar. In the present study hydraulic conductance (Lp) and diffusional water flux (J5) of human and bovine dentin slices were compared. The permeability experiments were performed in a split chamber using tritiated water in physiological saline. Lp and Js of bovine dentin were 0.7- to 2.4-fold and 1.1- to 3.5-fold that of human dentin (not statistically significant). For human and bovine dentin Lp and Js increased with etching and showed an inverse linear relationship (r > or = 0.7) with dentin thickness. The variability of bovine data was low (perfusion = 30%, diffusion = 22%) and about half that of the human data. In conclusion bovine dentin near the cementoenamel junction seems to be a suitable alternative for coronal human dentin for in vitro tests with respect to transdentinal permeability characteristics.

The study focused on changes in elasticity that accompany water storage of a synthetic orthodontic elastomer. We plotted loading and unloading curves to permit the direct measurement of instantaneous elastic recovery (IER) and permanent set (PS) and the calculation of delayed recovery (DR). We obtained baseline data by testing dry as received material. Comparable tests were performed on material that had been stored in water at 37 degrees C for one, seven, 14, 42, and 70 days. Gas chromatography-mass spectrometry was used for analysis of organic substances leached from the elastomer by water. A two-way ANOVA revealed that extension distance and water storage duration affected load requirement, IER, PS, and DR. The presence of leachable organic substances in 14-, 42-, and 70-day storage water was evidence of time-dependent matrix decomposition. Findings from tests of elastic performance and analysis of specimen storage water indicate that exposure of the elastomer to water leads first to weakening of noncovalent forces and subsequently to degradation.

A test pattern composed of 14 gauge sprue wax and various gauges of nylon lines was constructed, and used to differentiate the castability of several alloys. The castability of seven commercial low gold content alloys for porcelain fused to metal restorations was compared. Five commercial low gold content yellow alloys for full cast restorations were compared to each other and to a Type III certified control.

The mutagenic potential of dimethyl phthalate (DMP), diethyl phthalate (DEP), dibutyl phthalate (DBP), and di-2-ethylhexyl phthalate (DEPH), as well as metabolites of DEHP--i.e., mono-2-ethylhexyl phthalate (MEHP), 2-ethylhexanol (2-EH), and phthalic acid (PA)--were tested in Salmonella typhimurium cultures using the Ames test procedure. The compounds were tested on strains TA98, TA100, TA1535, TA1537, TA1538, and TA2637 for base-pair substitution or frameshift-type mutations. Spot tests yielded negative responses for all compounds with the strains tested. Each compound was tested for a dose-effect relationship in the TA98, TA100, TA1535, and TA1538 systems. DEP and DBP exhibited a mildly positive response in both TA100 and TA1535 cultures, and DMP showed a similar response in TA1535. Normalization of the data for cytotoxicity of DMP suggests TA100 has a mildly positive effect. The higher doses of these compounds exhibited some cytotoxic effects. The mutagenic effects were apparently abolished by the addition of S9 fraction in TA100 and TA1535 cultures, while no effect, other than cytotoxicity, was observed in the TA98 and TA1538 systems. DEHP, MEHP, 2-EH, and PA exhibited no mutagenicity in any of the strains of Salmonella typhimurium tested, with or without S9 metabolic activation. MEHP and 2-EH, however, exhibited a moderate cytotoxic effect in most cultures.