River engineering investigations require some level of hydrodynamic and morphologic analysis. The detailed of the hydraulic and morphologic features through meander evolution can be recorded by the numerical model spatially and temporally. The Center for Computational Hydro-science and Engineering, two- dimensional model (CCHE2D V3.29) was adopted to investigate the hydraulic and morphologic changes through meander’s evolution. Through the experimental work, a series of experiments runs were carried out through combining different geometric and hydraulic parameters to produce different experiment conditions. These parameters are flow rate, bed slope, and different initial incised and wide channels for both rectangular and trapezoidal sections. The CCHE2D model was calibrated and verified using two sets of experimental data. According to the computed values of statistical indicators, BIAS, NSE, and MAE of 0.0084, 0.96, and 0.0132 respectively for water level simulation, and 0.007,0.94, and 0.0182 respectively for bed level simulation, the calibrated Manning’s roughness which gives an acceptable agreement between simulated and measured water and bed levels was 0.029. The verification results were evaluated by the same statistical indicators of BIAS, NSE, and MAE of 0.09, 0.81, and 0.018, respectively, as evidenced by the statistical indicators, values that the CCHE2D model was reasonably capable of simulating the hydraulic and morphological changes through meander evolution.

No abstract

Morphological relationships of meander evolution in terms of hydraulic and geometric characteristics are essential for river management. In present study, an experimental based study of meander evolution was employed to develop a prediction formula for identifying the pool-point bar location by using the dimensional analysis technique and multiple nonlinear regressions. Through the experimental work on a race of the non-uniform river sand, a set of experimental runs have been carried out through combining different hydraulic and geometric parameters to produce different empirical conditions that have a direct impact on the pool-point bar location. Based on the experimental observations and measurements, the variation in pool–point bar locations could be interpreted to that the hydraulic and morphologic properties through the meander evolution were varied during the time causes the variations in the patterns of the pool-point bar formations accordingly. The developed formula was verified by using another set of the experimental data and tested with three statistical indicators. The predicted results indicated that the proposed formula had high reliability for practical estimation of the pool-point bar location. This reliability was tested by the statistical indicators, where the less values have been resulted for bias and mean absolute error (MAE), 0.0004 and 0.0110 respectively, whereas the higher values 0.935 and 0.930 are achieved for the Nash–Sutcliffe efficiency (NSE) and the determination coefficient R2, respectively.

No abstract

No abstract