No abstract

The research on two-stroke engines has been focused lately on the development of direct injection systems for reducing the emissions of hydrocarbons by minimizing the fuel short-circuiting. Low temperature combustion (LTC) may be the next step to further improve emissions and fuel consumption; however, LTC requires unconventional ignition systems. Jet ignition, i.e., the use of prechambers to accelerate the combustion process, turned out to be an effective way to perform LTC. The present work aims at proving the feasibility of adopting passive prechambers in a high-pressure, direct injection, two-stroke engine through non-reactive computational fluid dynamics analyses. The goal of the analysis is the evaluation of the prechamber performance in terms of both scavenging efficiency of burnt gases and fuel/air mixture formation inside the prechamber volume itself, in order to guarantee the mixture ignitability. Two prechamber geometries, featuring different aspect ratios and orifice numbers, were investigated. The analyses were replicated for two different locations of the injection and for three operating conditions of the engine in terms of revolution speed and load. Upon examination of the results, the effectiveness of both prechambers was found to be strongly dependent on the injection setup.

No abstract

The engine and vehicle design in Formula SAE competition has to accomplish a strict regulation. In order to limit the maximum power, an air restrictor of 20mm of diameter is imposed in the intake line. To overcome the limitations caused by the restrictor, Firenze Race Team equipped its one-cylinder engine with a turbocharger, which is conventionally provided with a wastegate (WG) valve to limit the maximum boost pressure and avoid knocking phenomena. Typically, the WG valve is controlled by a pneumatic actuator, which opens the valve according to a defined and constant maximum boost pressure downstream the compressor in the whole engine operating range. Therefore, the boost pressure at high engine speed, in which knocking problems are less intense and the volumetric efficiency is lower, is limited by the threshold value defined at medium-low engine speeds, i.e. the pneumatic WG limits the maximum power that the engine can supply. In this study, the implementation of an electronic control system for the WG valve is described together with a dedicated control strategy aimed at providing the desired boost pressure at full load for each engine speed, in order to get the maximum power avoiding knocking phenomena. The electronic WG provided higher power values and a more extended torque curve in comparison to the conventional pneumatic one

No abstract