Ecotoxicity testing is a crucial component of chemical risk assessment. Still, due to methodological difficulties related to controlling exposure concentrations over time, data on long-term effects of organic chemicals at low concentrations are limited. The aim of the present study was, therefore, to test the applicability of passive dosing to maintain stable concentrations of the organochlorine bacteriocide triclosan in the water phase during a 6-wk multigeneration population development test with the harpacticoid copepod Nitocra spinipes. Triclosan was loaded into silicone (1000 mg), which was used as passive dosing phase in the exposure vials. The distribution ratio for triclosan between silicone and water (D silicone-water ) was 10466 AE 1927. A population development test was conducted at 3 concentration levels of triclosan that were measured to be 3 mg/L to 5 mg/L, 7 mg/L to 11 mg/L and 16 mg/L to 26 mg/L. The results demonstrate that passive dosing is applicable for long-term ecotoxicity testing of organic chemicals, including during significant growth of the test organism population. Shifts in the demographic structure of the population during exposure suggest the most severe effects were exerted on juvenile development. Progressively lower development index values in the populations exposed to increasing triclosan concentrations suggest developmental retardation. The results further stress the need for chronic exposure during ecotoxicity testing in chemical risk assessment because even the most sensitive endpoint was not significant until after 7 d of exposure.

Contaminated sediment can release hydrophobic organic contaminants (HOCs) and thereby act as a secondary source of primarily legacy hazardous substances to the water column. There is therefore a need for assessments of the release of HOCs from contaminated sediment for prioritization of management actions. In situ assessment of HOC sediment-to-water flux is currently done with (closed) benthic flux chambers, which have a sampling time exceeding one month. During this time, the water inside the chamber is depleted of oxygen and the effect of bioturbation on the sediment-to-water release of HOCs is largely ignored. Here we present a novel benthic flux chamber, which measures sediment-to-water flux of legacy HOCs within days, and includes the effect of bioturbation since ambient oxygen levels inside the chamber are maintained by continuous pumping of water through the chamber. This chamber design allows for sediment-to-water flux measurements under more natural conditions. The chamber design was tested in a contaminated Baltic Sea bay. Measured fluxes were 62-2300 ng m d for individual polycyclic aromatic hydrocarbons (PAHs), and 5.5-150 ng m d for polychlorinated biphenyls (PCBs). These fluxes were 3-23 times (PAHs) and 12-74 times (PCBs) higher than fluxes measured with closed benthic chambers deployed in parallel at the same location. We hypothesize that the observed difference in HOC flux between the two chamber designs are partly an effect of bioturbation. This hypothesized effect of bioturbation was in accordance with literature data from experimental studies.

In the present study a recently developed benthic flow‐through chamber was used to assess the sediment‐to‐water flux of polycyclic aromatic hydrocarbons (PAHs) at 4 sites on the Swedish Baltic Sea coast. The flow‐through chamber allows for assessment of the potential effect of bioturbation on the sediment‐to‐water flux of hydrophobic organic contaminants. The sediments at the 4 investigated sites have both varying contamination degree and densities of bioturbating organisms. The flux of individual PAHs measured with the flow‐through chamber ranged between 21 and 510, 11 and 370, 3 and 9700, and 62 and 2300 ng m–2 d–1 for the 4 sites. To assess the potential effect of bioturbation on the sediment‐to‐water flux, 3 flow‐through and closed chambers were deployed in parallel at each site. The activity of benthic organisms is attenuated or halted because of depletion of oxygen in closed benthic chambers. Therefore, the discrepancy in flux measured with the 2 different chamber designs was used as an indication of a possible effect of bioturbation. A potential effect of bioturbation on the sediment‐to‐water flux by a factor of 3 to 55 was observed at sites with a high density of bioturbating organisms (e.g., Marenzelleria spp., Monoporeia affinis, and Macoma balthica of approximately 860–1200 individuals m–2) but not at the site with much lower organism density (<200 individuals m–2). One site had a high organism density and a low potential effect of bioturbation, which we hypothesize to be caused by the dominance of oligochaetes/polychaetes at this site because worms (Marenzelleria spp.) reach deeper into the sediment than native crustaceans and mollusks. Environ Toxicol Chem 2019;38:1803–1810. © 2019 SETAC

Stable nitrogen isotopes (δN) are used as indicators of trophic position (TP) of consumers. Deriving TP from δN of individual amino acids (AAs) is becoming popular in ecological studies, because of lower uncertainty than TP based on bulk δN (TP). This method would also facilitate biomagnification studies provided that isotope fractionation is unaffected by toxic exposure. We compared TP and TP estimates for a sediment-dwelling bivalve from two coastal sites, a pristine and a contaminated. Chemical analysis of PCB levels in mussels, sediments, and pore water confirmed the expected difference between sites. Both methods, but in particular the TP underestimated the actual TP of bivalves. Using error propagation, the total uncertainty related to the analytical precision and assumptions in the TP calculations was found to be similar between the two methods. Interestingly, the significantly higher intercept for the regression between TP and TP in the contaminated site compared to the pristine site indicates a higher deamination rate due to detoxification as a result of chronic exposure and a higher N fractionation. Hence, there is a need for controlled experiments on assumptions underlying amino acid-specific stable isotope methods in food web and bimagnification studies.

Environmental mixtures of chemicals consist of a countless number of compounds with unknown identity and quantity. Yet, chemical regulation is mainly built around the assessment of single chemicals. Existing frameworks for assessing the toxicity of mixtures require that both the chemical composition and quantity are known. Quantitative analyses of the chemical composition of environmental mixtures are however extremely challenging and resource-demanding. Bioassays may therefore serve as a useful approach for investigating the combined toxicity of environmental mixtures of chemicals in a cost-efficient and holistic manner. In this study, an unknown environmental mixture of bioavailable semi-hydrophobic to hydrophobic chemicals was sampled from a contaminated sediment in a coastal Baltic Sea area using silicone polydimethylsiloxane (PDMS) as an equilibrium passive sampler. The chemical mixture was transferred to a PDMS-based passive dosing system, and its applicability was demonstrated using green algae Tetraselmis suecica in a cell viability assay. The proportion of dead cells increased significantly with increasing exposure level and in a dose-response manner. At an ambient concentration, the proportion of dead cells in the population was nearly doubled compared to the control; however, the difference was non-significant due to high inter-replicate variability and a low number of replicates. The validation of the test system regarding equilibrium sampling, loading efficiency into the passive dosing polymer, stability of the mixture composition, and low algal mortality in control treatments demonstrates that combining equilibrium passive sampling and passive dosing is a promising tool for investigating the toxicity of bioavailable semi-hydrophobic and hydrophobic chemicals in complex environmental mixtures.