No abstract

In this work we report the properties of nanocomposite based on PET with two different samples of organically modified montmorillonites. In particular, we studied the effect of the filler concentration on morphology, rheology, and mechanical performance, focusing our attention on the effect of the degradation phenomena of the clay modifiers. The results indicate that at low clay level the morphology achieved is mainly intercalated. On increasing the filler level, coalescence and/or bad defragmentation phenomena induce a coarser morphology, as confirmed by XRD, SEM, and TEM observations. When a more polar organic modifier is used to modify the clay, the particle adhesion and distribution is slightly better.Conversely, at the processing temperatures adopted, this organic modifier induces a strong degradation of PET, as confirmed by melt rheology and intrinsic viscosity measurements. DSC indicates, in addition, a slight increase of crystallinity likely due to the decreased molecular weight. As regards the mechanical properties, Young's modulus is not significantly changed unless high amounts of clay (10%) are used while the elongation at break drops even at the lowest clay content.

Synthetic biopolymers are effective cues to replace damaged tissue in the tissue engineering (TE) field, both for in vitro and in vivo application. Among them, poly-l-lactic acid (PLLA) has been highlighted as a biomaterial with tunable mechanical properties and biodegradability that allows for the fabrication of porous scaffolds with different micro/nanostructures via various approaches. In this review, we discuss the structure of PLLA, its main properties, and the most recent advances in overcoming its hydrophobic, synthetic nature, which limits biological signaling and protein absorption. With this aim, PLLA-based scaffolds can be exposed to surface modification or combined with other biomaterials, such as natural or synthetic polymers and bioceramics. Further, various fabrication technologies, such as phase separation, electrospinning, and 3D printing, of PLLA-based scaffolds are scrutinized along with the in vitro and in vivo applications employed in various tissue repair strategies. Overall, this review focuses on the properties and applications of PLLA in the TE field, finally affording an insight into future directions and challenges to address an effective improvement of scaffold properties.

Abstract:Fibers spun by melt spinning of binary and ternary polypropylene/ polyethylenetherephthalate blends have been produced and characterized in order to investigate the effect of a compatibilizer on their morphology and mechanical properties. The compatibilizer was a maleic anhydride-functionalized rubber copolymer. The effect of the compatibilizer was well evident in the isotropic state, as the morphology became very fine, the size of the dispersed particles was very small, and the adhesion was better. The effect of the compatibilizer on the mechanical properties is very relevant, especially in the elongation at break. On the contrary, no relevant effect was observed in the anisotropic oriented fibers. Although the average diameter of the microfibrils of the dispersed phase of the compatibilized blend generated during the hot drawing was much smaller than that of the microfibrils of the same particles of the uncompatibilized blend, the mechanical properties were almost the same. This behavior has been attributed to the length of the smaller microfibrils of the ternary blends, which was lower that of the microfibrils of the binary blend. This has been explained in terms of reduced initial droplet size, and therefore of lesser possibility of stretching the droplets to very long fibrils in these samples.