A new composite scaffold containing type I collagen, hyaluronan, and fibrin was prepared with and without autologous chondrocytes and implanted into a rabbit femoral trochlea. The biophysical properties of the composite scaffold were similar to native cartilage. The macroscopic, histological, and immunohistochemical analysis of the regenerated tissue from cell-seeded scaffolds was performed 6 weeks after the implantation and predominantly showed formation of hyaline cartilage accompanied by production of glycosaminoglycans and type II collagen with minor fibro-cartilage production. Implanted scaffolds without cells healed predominantly as fibro-cartilage, although glycosaminoglycans and type II collagen, which form hyaline cartilage, were also observed. On the other hand, fibro-cartilage or fibrous tissue or both were only formed in the defects without scaffold. The new composite scaffold containing collagen type I, hyaluronan, and fibrin, seeded with autologous chondrocytes and implanted into rabbit femoral trochlea, was found to be highly effective in cartilage repair after only 6 weeks. The new composite scaffold can therefore enhance cartilage regeneration of osteochondral defects, by the supporting of the hyaline cartilage formation.

The study is focused on the biomechanical aspects of the anterior cruciate ligament (ACL) reconstruction procedures with an emphasis on evaluating the dynamic strain of materials commonly used for this purpose. Separate and multiple, equally tensioned strands of hamstring grafts used for the reconstruction of the ACL were biomechanically tested and compared to original ACL and bone-patellar tendon-bone (BPTB) grafts, using tissue samples from cadavers. The study was focused on measuring such material properties as the strength, stiffness, maximum load, and elongation at maximum load of the original ACL, BPTB graft, and single tendon hamstring (gracilis and semitendinosus) grafts, continued by double strands and finally by four-strand graft (STG) evaluation. Fresh-frozen cadaveric knees were used, which had been clamped and tensioned equally. The measurement was performed by drop-weight testing, using a Laser Doppler Vibrometer as a basic sensor of the dynamic movements of the gripping clamps, with parallel correlation by a piezoelectric transducer. The grafts for experiments were obtained from 21-paired knees. The measurement was performed at room temperature (21 degrees C) after 24 h of thawing at 4 degrees C. All the specimens were measured for their response to the dynamic tensile load. The maximum strength values were obtained and calculated for the appropriate section area of the specimen. The tensioned strands of the original ACL showed a maximum average load of 1,246 +/- 243 N in the section area of about 30 mm(2) (max. stress 41.3 MPa); the strands of BPTB grafts showed values of 3,855 +/- 550 N in the section area of 80 mm(2) (max. stress 40.6 MPa); the gracilis tendons showed 925 +/- 127 N in the section area of 10 mm(2) (max. stress 95.1 MPa) and the semitendinosuss yielded a result of 2,050 +/- 159 N in the area of 20 mm(2) (max. stress 88.7 MPa). Of all the materials, the original ACL have the lowest strength and stiffness in respect of their biomechanical properties. BPTB grafts showed a slightly higher value of maximum stress, while both the gracilis and semitendinosus tendons showed double the value of maximum load per section area-tensile stress. Two- and four- combined hamstring strands clamped together and equally tensioned with a drop-weight had the combined tensile strength properties of the individual strands within the estimated range of measurement errors. No significant changes in maximum loads/stresses were observed under impact loading conditions. The results of this study demonstrate that equally tensioned four-strand hamstring-tendon grafts have higher initial tensile properties than those in other varieties of samples. From a biomechanical point of view, they seem to be a reasonable alternative procedure for ACL reconstruction.

Small hydrophobic gold nanoparticles with diameter lower than the membrane thickness can form clusters or uniformly distribute within the hydrophobic core of the bilayer. The coexistence of two stable phases (clustered and dispersed) indicates the energy barrier between nanoparticles. We calculated the distance dependence of the membrane-mediated interaction between two adjacent nanoparticles. In our model we consider two deformation modes: the monolayer bending and the hydroxycarbon chain stretching. Existence of an energy barrier between the clustered and the separated state of nanoparticles was predicted. Variation analysis of the membrane mechanical parameters revealed that the energy barrier between two membrane embedded nanoparticles is mainly the consequence of the bending deformation and not change of the thickness of the bilayer in the vicinity of nanoparticles. It is shown, that the forces between the nanoparticles embedded in the biological membrane could be either attractive or repulsive, depending on the mutual distance between them.

For biodegradable porous scaffolds to have a potential application in cartilage regeneration, they should enable cell growth and differentiation and should have adequate mechanical properties. In this study, our aim was to prepare biocompatible scaffolds with improved biomechanical properties. To this end, we have developed foam scaffolds from poly-Ɛ-caprolactone (PCL) with incorporated chitosan microparticles. The scaffolds were prepared by a salt leaching technique from either 10 or 15 wt% PCL solutions containing 0, 10 and 20 wt% chitosan microparticles, where the same amount and size of NaCl was used as a porogen in all the cases. PCL scaffolds without and with low amounts of chitosan (0 and 10 wt% chitosan) showed higher DNA content than scaffolds with high amounts of chitosan during a 22-day experiment. 10 wt% PCL with 10 and 20 wt% chitosan showed significantly increased viscoelastic properties compared to 15 wt% PCL scaffolds with 0 and 10 wt% chitosan. Thus, 10 wt% PCL scaffolds with 0 wt% and 10 wt% chitosan are potential scaffolds for cartilage regeneration.