No abstract

An end-pumped Nd:YLF laser was demonstrated, which delivered 60.3 W continuous-wave and more than 52 W Q-switched average power for all repetition rates from 5 to 30 kHz. To achieve this, an analytical solution to estimate and optimize the unsaturated gain in an end-pumped laser gain medium was derived. The approach presented here should open up the route for scaling end-pumped lasers to even higher power and energy levels.

A time-dependent analytical thermal model of the temperature and the corresponding induced thermal stresses on the pump face of quasicontinuous wave (qcw) end-pumped laser rods is derived. We apply the model to qcw diode-end-pumped rods and show the maximum peak pump power that can be utilized without fracturing the rod. To illustrate an application of the model, it is applied to a qcw pumped Tm:YLF rod and found to be in very good agreement with published experimental results. The results indicate new criteria to avoid fracture when operating Tm:YLF rods at low qcw pump duty cycles.

We report systematic analysis and comparison of ps-laser microwelding of industry relevant Al6082 parts to SiO and BK7. Parameter mapping of pulse energy and focal depth on the weld strength is presented. The welding process was found to be strongly dependent on the focal plane but has a large tolerance to variation in pulse energy. Accelerated lifetime tests by thermal cycling from -50° to +90°C are presented. Welds in Al6082-BK7 parts survive over the full temperature range where the ratio of thermal expansion coefficients is 3.4:1. Welds in Al6082-SiO parts (ratio 47.1:1) survive only a limited temperature range.

A single-frequency single-pass amplifier based on Ho:YLF and Ho:LuLF in a scalable slab architecture delivering up to 210 mJ at 2064 nm is demonstrated. The amplifier was end-pumped by a 1890 nm Tm:YLF slab laser and was seeded with a 69 mJ single-frequency Ho:YLF ring laser operating at 50 Hz.