The main aim of the study was to evaluate the use of positron emission tomography using fluoro-deoxyglucose (PET-FDG) imaging for the detection of squamous cell carcinoma of the head and neck. Fifty-four consecutive patients with malignancies involving the head and neck were studied prospectively. Thirty-one patients presented with primary disease and 23 were suspected of recurrent or residual disease. All patients underwent full clinical staging, PET-FDG scans and anatomical imaging, 37 underwent computed tomography (CT), 13 magnetic resonance (MR) and four had both CT and MR. Clinical assessment, CT/MR, PET-FDG and histological examination were all evaluated independently of each other. All 31 primary head and neck malignant tumours were detected by PET-FDG. Based on 16 patients who underwent neck dissections, the sensitivity and specificity of PET-FDG for detecting nodal disease was 67% and 100% respectively, compared with clinical assessment of 58% and 75% and CT/MR of 67% and 25%. In all 12 patients, PET-FDG correctly identified the presence of absence or recurrent or residual disease. PET-FDG staged 13 post-treatment necks with an accuracy of 100% as compared to CT/MR which was accurate in 7 of 13 and clinical assessment which was accurate in eight. Three sites of abnormal tracer uptake unrelated to malignancy were recorded as incidental findings (mandibular osteomyelitis, 1: post glossectomy site, 2). PET-FDG was more accurate than CT/MR for identifying primary and recurrent tumours as well as metastatic lesions in the neck. If these diagnostic properties of PET-FDG are confirmed in further prospective studies, it could prove a valuable adjunct for the management of head and neck cancer.

No abstract

The revision of an orthopaedic procedure can present surgeons with the challenge of a complex reconstructive process. Orthopaedic surgery can also face considerable challenges in cases presenting extensive primary injuries with multiple bone fragmentation, as well as in cases presenting bone deformities. Radiographs are used routinely for orthopaedic surgical planning, yet they provide inadequate information on the precise three-dimensional extent of bone defects. Three-dimensional reconstructions from X-ray computed tomography offer superior visualization but are not portable for consultation or readily available in the operating theatre for guidance during a procedure. A physical model manufactured from X-ray computed tomography data can offer surgeons a clear understanding of complex anatomical detail, by providing an intuitive physical relationship between patient and model. Rapid prototyping was used for the construction of an anatomical model in a case presenting with a complex shoulder injury. The model provided a definitive interpretation of joint pathology and enabled a full assessment of the degree of injury.

Wide local excision with clear resection margins is essential to achieve local control and long-term survival. There is a need for cross-specialty collaboration in order to accrue the evidence which will be necessary to improve long-term outcomes.

If citing, it is advised that you check and use the publisher's definitive version for pagination, volume/issue, and date of publication details. And where the final published version is provided on the Research Portal, if citing you are again advised to check the publisher's website for any subsequent corrections.