The bacteriological composition and ultrastructure of mesophilic granular methanogenic sludge from a large-scale Upflow Anaerobic Sludge Blanket reactor treating wastewater from a sugar plant and of sludge granules adapted to ethanol and propionate were studied by counting different bacterial groups and by immunocytochemical methods. Propionate-grown granular sludge consisted of two types of clusters, those of a rod-shaped bacterium immunologically related to Methanothrix soehngenii and those consisting of two different types of bacteria with a specific spatial orientation. One of these bacteria reacted with antiserum against Methanobrevibacter arboriphilus AZ, whereas the other is most likely a propionate-oxidizing bacterium immunologically unrelated to Syntrophobacter wolinii. Sludge granules obtained from the large-scale Upflow Anaerobic Sludge Blanket reactor and granules cultivated on ethanol did not show the typical spatial orientation of bacteria. Examination of the bacterial composition of the three types of granules by light and electron microscopy, the most-probable-number method, and by isolations showed that M. arboriphilus and M. soehngenii were the most abundant hydrogenotrophic and acetoclastic methanogens in propionate-grown sludge. Methanospirillum hungatei and Methanosarcina barkeri predominated in ethanol-grown granules, whereas many morphotypes of methanogens were abundant in granules from the full-scale reactor.

No abstract

Bioalkylation and colloid formation of selenium during selenate removal in upflow anaerobic sludge bed (UASB) bioreactors was investigated. The mesophilic (30 degrees C) UASB reactor (pH = 7.0) was operated for 175 d with lactate as electron donor at an organic loading rate of 2 g COD L(-1) d(-1) and a selenium loading rate of 3.16 mg Se L(-1) d(-1). Combining sequential filtration with ion chromatographic analysis for selenium oxyanions and solid phase micro extraction gas chromatography mass spectrometry (SPME-GC-MS) for alkylated selenium compounds allowed to entirely close the selenium mass balance in the liquid phase for most of the UASB operational runtime. Although selenate was removed to more than 98.6% from the liquid phase, a less efficient removal of dissolved selenium was observed due to the presence of dissolved alkylated selenium species (dimethylselenide and dimethyldiselenide) and colloidal selenium particles in the effluent. The alkylated and the colloidal fractions contributed up to 15 and 31%, respectively, to the dissolved selenium concentration. The size fractions of the colloidal dispersion were: 4 to 0.45 mum: up to 21%, 0.45 to 0.2 mum: up to 11%, and particles smaller than 0.2 mum: up to 8%. Particles of 4 to 0.45 mum were formed in the external settler, but did not settle. SEM-EDX analysis showed that microorganisms form these selenium containing colloidal particles extracellularly on their surface. Lowering the temperature by 10 degrees C for 6 h resulted in drastically reduced selenate removal efficiencies (after a delay of 1.5 d), accompanied by the temporary formation of an unknown, soluble, organic selenium species. This study shows that a careful process control is a prerequisite for selenium treatment in UASB bioreactors, as disturbances in the operational conditions induce elevated selenium effluent concentrations by alkylation and colloid formation.

Extracellular polymers were localized and quantitatively analysed in methanogenic granular sludge cultivated on either propionate or ethanol in laboratory upflow anaerobic sludge-blanket (UASB) reactors. Electron microscopical analysis of ultrathin sections of the two sludge types stained with ruthenium red revealed the presence of extracellular polymers with different densities and structures. For quantification, granular sludge from a large-scale UASB reactor at a liquid sugar plant was also included in this study. A three-step physical disintegration procedure was used to extract water-soluble extracellular material from the granules. After each disintegration step the extracts were analysed for polysaccharides and proteins. Cell damage and thus the contribution of intracellular proteins and polysaccharides was estimated simultaneously by the determination of free DNA and free ATP in the extracts. After two extraction steps, up to 3.5 mg polysaccharides/g organic material and 5.5 mg protein/g organic material were extracted, whereas no significant increase in DNA was detected. The role of extracellular polymers in granular stability is discussed.