Magnetic random access memory schemes employing magnetoelectric coupling to write binary information promise outstanding energy efficiency. We propose and demonstrate a purely antiferromagnetic magnetoelectric random access memory (AF-MERAM) that offers a remarkable 50-fold reduction of the writing threshold compared with ferromagnet-based counterparts, is robust against magnetic disturbances and exhibits no ferromagnetic hysteresis losses. Using the magnetoelectric antiferromagnet Cr2O3, we demonstrate reliable isothermal switching via gate voltage pulses and all-electric readout at room temperature. As no ferromagnetic component is present in the system, the writing magnetic field does not need to be pulsed for readout, allowing permanent magnets to be used. Based on our prototypes, we construct a comprehensive model of the magnetoelectric selection mechanisms in thin films of magnetoelectric antiferromagnets, revealing misfit induced ferrimagnetism as an important factor. Beyond memory applications, the AF-MERAM concept introduces a general all-electric interface for antiferromagnets and should find wide applicability in antiferromagnetic spintronics.

Electric-field-controlled magnetism can boost energy efficiency in widespread applications. However, technologically, this effect is facing important challenges: mechanical failure in strain-mediated piezoelectric/magnetostrictive devices, dearth of room-temperature multiferroics, or stringent thickness limitations in electrically charged metallic films. Voltage-driven ionic motion (magneto-ionics) circumvents most of these drawbacks while exhibiting interesting magnetoelectric phenomena. Nevertheless, magneto-ionics typically requires heat treatments and multicomponent heterostructures. Here we report on the electrolytegated and defect-mediated O and Co transport in a Co 3 O 4 single layer which allows for room-temperature voltage-controlled ON−OFF ferromagnetism (magnetic switch) via internal reduction/oxidation processes. Negative voltages partially reduce Co 3 O 4 to Co (ferromagnetism: ON), resulting in graded films including Co-and O-rich areas. Positive bias oxidizes Co back to Co 3 O 4 (paramagnetism: OFF). This electric-field-induced atomic-scale reconfiguration process is compositionally, structurally, and magnetically reversible and self-sustained, since no oxygen source other than the Co 3 O 4 itself is required. This process could lead to electric-field-controlled device concepts for spintronics.

Magneto-ionics, understood as voltage-driven ion transport in magnetic materials, has largely relied on controlled migration of oxygen ions. Here, we demonstrate room-temperature voltage-driven nitrogen transport (i.e., nitrogen magneto-ionics) by electrolyte-gating of a CoN film. Nitrogen magneto-ionics in CoN is compared to oxygen magneto-ionics in Co3O4. Both materials are nanocrystalline (face-centered cubic structure) and show reversible voltage-driven ON-OFF ferromagnetism. In contrast to oxygen, nitrogen transport occurs uniformly creating a plane-wave-like migration front, without assistance of diffusion channels. Remarkably, nitrogen magneto-ionics requires lower threshold voltages and exhibits enhanced rates and cyclability. This is due to the lower activation energy for ion diffusion and the lower electronegativity of nitrogen compared to oxygen. These results may open new avenues in applications such as brain-inspired computing or iontronics in general.

No abstract

Sub-100-nm magnetic dots embedded in a non-magnetic matrix are controllably generated by selective ion irradiation of paramagnetic Fe(60)Al(40) (atomic %) alloys, taking advantage of the disorder-induced magnetism in this material. The process is demonstrated by sequential focused ion beam irradiation and by in-parallel broad-beam ion irradiation through lithographed masks. Due to the low fluences used, this method results in practically no alteration of the surface roughness. The dots exhibit a range of magnetic properties depending on the size and shape of the structures, with the smallest dots (<100 nm) having square hysteresis loops with coercivities in excess of micro(0)H(C) = 50 mT. Importantly, the patterning can be fully removed by annealing. The combination of properties induced by the direct magnetic patterning is appealing for a wide range of applications, such as patterned media, magnetic separators, or sensors.