The scarcity of water can result in a direct conflict between the protection of aquatic resources and water use. For many agencies, environmental flow (EF) methods are essential in environmental impact assessments and in the protection of important fisheries resources. The objective of this paper is to compare selected hydrological and hydraulic methods and determine the scientifically acceptable and cost-effective way to environmental flow within a section of a mountain river with high naturalness, on the example of the Wisłoka. In this paper, environmental flow was calculated using conventional hydrological methods: Tennant’s, Tessman’s, flow duration curve and hydraulic methods, wetted perimeter method (WPM) and method based directly on ichthyofauna habitat requirements (spawn and migration). The novelty is the combined use of the hydraulic and hydrological methods which relates to flow hydraulics based directly on ichthyofauna habitat conditions. The hydraulic methods provide lower values of environmental flow in comparison with the hydrological methods. The key issue in the use of the hydraulic methods is the choice of criteria. The development of the required set of parameters while taking into account their seasonal nature shifts the method toward habitat modeling methods. However, the scope of habitat requirements of ecosystems must be defined, including the set of aquatic organisms and watercourse type before a hydraulic method may be widely used. Being generally low-cost and simple, the methods presented in this paper can be applied in the water management legislative process.

The aim of the study was to assess the properties of bottom sediments from the inlet zone of the Rożnów Reservoir (South Poland) and to analyse the potential possibilities to use them for environmental purposes. The inlet zone of the reservoir is particularly intensely shallowed by means of the silts of the Dunajec River. A total of 20 samples were collected from the designated cross-sections. In air-dry samples of the sediments, granulometric composition, pH electrolytic conductivity (EC), sorption properties, organic carbon carbonates and macroelements content were determined. Bottom sediments from the Rożnów Reservoir indicate a great potential possibility to use them for environmental purposes (agriculture, reclamation). However, in order to fully evaluate the possibility of bottom sediment management, it is necessary to carry out an analysis of the ecological risk related to the content of heavy metals, PAHs, PCBs and to evaluate their eco-toxicity. Moreover, the main barriers to the environmental application of bottom sediments are a lack of appropriate legislation.

Two sets of triangular hydrographs were generated in a 12-m-long laboratory flume for two sets of initial bed conditions: intact and water-worked gravel bed. Flowrate ranging from 0.0013 m 3 s -1 to 0.0456 m 3 s -1 , water level ranging from 0.02 m to 0.11 m, and cumulative mass of transported sediment ranging from 4.5 kg to 14.2 kg were measured. Then, bedload transport rate, water surface slope, bed shear stress, and stream power were evaluated. The results indicated the impact of initial bed conditions and flow unsteadiness on bedload transport rate and total sediment yield. Difference in ratio between the amount of supplied sediment and total sediment yield for tests with different initial conditions was observed. Bedload rate, bed shear stress, and stream power demonstrated clock-wise hysteretic relation with flowrate. The study revealed practical aspects of experimental design, performance, and data analysis. Water surface slope evaluation based on spatial water depth data was discussed. It was shown that for certain conditions stream power was more adequate for the analysis of sediment transport dynamics than the bed shear stress. The relations between bedload transport dynamics, and flow and sediment parameters obtained by dimensional and multiple regression analysis were presented.

No abstract

No abstract