The aim of this publication is to analyze the influence of rock mineral composition and rock geometric properties on the quality of crushed aggregates, from the perspective of selecting an adequate aggregate production technology. This research is based on samples of crushed aggregates from plants processing igneous rocks from four different igneous deposits. In the case of the geometric properties, shape and flakiness indexes were identified and subsequently analyzed along with particle size distribution. The performed tests allowed a conclusion that the shape of the particle is influenced by the mineral composition and size distribution. The grain size analysis demonstrated that flaky and non-cubical particles concentrate in the finest grain fractions, and the least variable shape index is observed for basalt aggregate. Some problems were also observed to exist in relation to the classification of grain shape. In the literature, the notions of regular and irregular grains seem to be used interchangeably with the notions of flaky and non-flaky grains. The performed tests show that flaky grains do not necessarily have to be non-cubical and vice versa. Therefore, this article proposes an approach in which the applied technique is precisely explained and the shape of grains is described with four notions: cubical, non-cubical, flaky, and non-flaky. The article also finally concludes that the next step in the research on selecting an optimal production technology of high-quality aggregates should be to analyze the selection of the fragmentation process while also characterizing the geometric properties of the aggregates.

Abstract. Ore liberation is one of the most important parameter in mineral processing, especially in flotation. To separate the valuable components from gangue minerals, it is necessary to liberate one from others. It is achieve primarily through crushing and grinding. These stages are one of the most expensive of mineral production. It is important to determine the adequate mineral liberation which would result in huge savings in the overall cost of flotation plant. The aim of the paper was the analysis of the influence of milling time on the laboratory flotation of the copper ore from stratiform Polish deposit. Three different milling time of copper ore in laboratory ball mill was applied. The flotation results were presented as the recovery-recovery and grade-recovery upgrading curves. The liberation of sulphides and the particle size of sulphides in flotation product were analysed and compared.

Abstract. Flotation of carbonaceous copper-bearing shale and copper sulfide minerals such as chalcocite and bornite in the presence of only frother was investigated. It was determined that all investigated solids did not float in pure water in the absence of flotation reagents. However, an addition of a frother rendered both shale and bornite floatable, while the recovery of chalcocite was negligible. These findings suggest that removal of carbonaceous matter from the ore by the so-called pre-flotation process can be a suitable procedure to reduce the amount of organic carbon in the concentrates provided that the feed does not contain bornite. Otherwise, simple pre-flotation must be replaced with a more sophisticated process in which flotation of bornite is suppressed.

No abstract