The sequential adsorption of oppositely charged polyelectrolytes called the "layer by layer" technique is a method for formation of ultrathin films with controlled thickness and interfacial properties. Composition of polyelectrolyte solutions, pH, and electrolyte concentration are important parameters governing formation of multilayer films. Since pH is the factor controlling charge of weak polyelectrolytes, the structure of multilayers should be sensitive to its value. In this paper we focused on formation of PE multilayer films composed from weak and strong polyelectrolytes. We used weak, branched polycation polyethyleneimine (PEI, 70 kDa) and strong polyanion poly-4-styrenesulfonate (PSS, 70 kDa) to form films by the layer-by-layer technique on the surface of silicon wafers under two deposition conditions: pH = 6 when PEI was strongly charged and pH = 10.5 when the charge density of PEI was low. Thicknesses of films were measured by single wavelength ellipsometry, and the results were confronted with ones concerning mass of the adsorbed films obtained by quartz crystal microbalance. We found that, depending on pH of the solutions, combination of weakly and strongly charged polyelectrolytes gave either linear or nonmonotonic increase of film thickness with a number of deposited PE layers. We observed a good correlation between multilayer film thickness and adsorbed mass. The atomic force microscopy images of surface topography of PEI/PSS films demonstrated large differences between films deposited at pH = 6 and 10.5. Additionally the cyclic voltamperometry was used to determine the differences in permeability of films formed at various pH conditions.

No abstract

No abstract

Polyelectrolyte films structure formed by the "layer-by-layer" (LbL) technique can be enriched by addition of charged nanoparticles like carbon nanotubes and silver or hydroxyapatite nanoparticles, which can improve properties of the polyelectrolyte films or modify their functionality. In our paper we examined the formation and properties of model polyelectrolyte multilayers containing a synthetic layered silicate, Laponite. The Laponite nanoparticles were incorporated into multilayer films, which were formed from weak, branched polycation PEI and strong polyanion PSS. Since charge of PEI is pH-dependent, we build up multilayer films in two deposition conditions: pH = 6 when PEI was strongly charged and pH = 10.5 when charge density of PEI was low. Thicknesses of the films constructed with various numbers of Laponite layers were measured by single wavelength ellipsometry. We also determined the differences in permeability for selected electroactive molecules using cyclic voltamperometry. Properties of the films containing clay nanoparticles were compared with model polyelectrolyte multilayer films PEI/PSS formed at the same conditions. We found that Laponite nanoparticles strongly influenced PEI/PSS multilayer film properties. Replacement of PSS by Laponite eliminated the oscillations of the film thickness in the case when PEI was weakly charged. PSS layer adsorbed on top of PEI/Laponite bilayers increased the thickness of multilayer films and improved their barrier properties so synergistic effects between these properties for polyelectrolytes and Laponite nanoparticles could be observed.